Filter
Top Products
INSTRUCTION FOR USE
3
– When blending hot liquids, remove the lid cap (center-
piece of two-piece cover), and close any edge cover open-
ings intended for pouring.
– Do not let the cord hang over the edge of the table or
counter or touch hot surfaces, including the stove.
– Disconnect the blender from the mains whenever it is not
being used, before attaching or removing accessories or
when cleaning it.
– Do not operate any appliance with a damaged cord or
plug, or after the appliance malfunctions or has been
damaged in any way. Instead, take it to the nearest
authorised service centre for examination, repair or
adjustment.
– Never attempt to replace the cord, as special tools are
required. Repairs to or replacements of the cord should
be left to a service centre authorised by the manufacturer
to ensure the safety of the appliance.
– Never immerse the cord, motor base or plug in water
or other liquid, as this could cause fire, electric shock or
injury.
– CAUTION: to avoid the risk of overriding the safety shut-
down system, the appliance must not be operated by
means of an external switch device such as a time switch,
nor should it be connected to an electrical circuit that is
regularly switched on and off by the electricity supply
company.
– The appliance must remain disconnected from the mains
while it is being cleaned.
– Blades are sharp, handle carefully
– Do not touch any rotating components or accessories.
– Flashing light indicates ready to operate. Avoid any con-
tact with blades. Keep clothing, jewelry, hair, fingers and
utensils away from rotating components or accessories to
avoid serious injury to persons and damage to the appli-
ance.
– Check that the appliance is isolated from the mains
before cleaning or putting it away.
– Always operate blender with lid in place.
SAVE THESE INSTRUCTIONS