Bosch Appliances 119 Dishwasher User Manual


 
8 - ENGLISH
www.boschappliances.com
PLACING THE DISHWASHER
Placing the Dishwasher
The profile strips on the sides of the
dishwasher allow the dishwasher to fit into
a cabinet opening with a width of 24” (610
mm) to 24-1/4” (616 mm). Before sliding
the dishwasher into the cabinet opening:
Straighten the hot water supply line and
the electrical cable (see Figure 11).
Level & Align (initial adjustments).
Guide the
drain hose
carefully (avoiding
kinks in hose) as the dishwasher is slid
into the cabinet opening.
Make final leveling adjustments (see
FINAL STEPS Section).
Mount the dishwasher to maintain
positioning and alignment. Determine
which type of mounting your
dishwasher needs:
Top Mount is used for all types of
countertops that
will not
be damaged
by drilling.
For a top mount, position the
brackets flat on each of the top
corners of the dishwasher as
shown in Figure 10A.
Side Mount is used when there is a
granite, marble or other hard natural
surface counter top that could be
damaged by drilling.
For a side mount, bend the
brackets, then position them as
shown in Figure 10B.
Drive Mounting Screws (see Figure 3)
through the holes in the brackets. See
Figure 10A or 10B.
Connect the drain hose, hot water
supply line and electrical connections
as described in the following sections.
IMPORTANT
If you wish to change the front panel of
the dishwasher this must be done before
sliding the dishwasher into place.
*Note: Additional accessory door pa-
nels can not be used with SHU 9900
models.
Figure 10
A
B
A. Mounting bracket
for mounting to under
countertop
B. Mounting bracket
bent
for mounting to
side of cabinets
Figure 11
Level