Filter
Top Products
aus
17
Terminating the programme
(Reset)
Only when the main switch is on:
Rotate programme selector to the
Reset position.
The programme sequence lasts
approx. 1 min.
When the programme has run,
switch off the main switch
1 .
To restart, rotate the programme selector
3 to the required programme. Switch on
the main switch
1 . The programme
sequence starts automatically.
Changing the programme
It is possible to change the programme
within 2 minutes after you have switched
the dishwasher on.
Should it be necessary to change the
programme after this period, the
programme cycle that has already been
begun (e.g. washing) will be completed
first of all.
Note
If the power supply is
disconnected while the appliance
is operating, e.g. by switching off
the appliance or due to a power
failure, all settings remain stored.
Operation continues automatically
as soon as the power supply is
restored.
Additional functions
* on some models additional functions
4 can be set with the buttons.
Pre-Soak *
The Pre-Soak programme option serves to
perform a pre-soak cycle before the main
programme. This cycle enables cookware,
e.g. pans, bowls, etc. to be pre-soaked
and pre-rinsed in the lower rack. If you
wish to pre-soak the dishes, this
programme option must be selected by
pressing the “Pre-Soak” button before the
programme starts. The recommended
detergent amount is approx. 5 g poured
onto the inside of the door.
Time reduction/ time saving *
Pressing the “Time reduction/time saving”
button provides a short wash cycle by
curtailing the drying phase and the
washing time. The washing and drying
performance will be reduced with the Time
reduction/time saving programme option.
Washing contents of UPPER
RACK only *
If you have a small number of dishes to
wash in the upper rack (e.g. glasses, cups,
plates), switch on the UPPER RACK
function. If you select the UPPER RACK
function, the lower rack must be empty.
Add a reduced amount of detergent
compared to that which is recommended
for a full load.
Washing contents of
LOWER RACK only *
If you have a small number of dishes to
wash in the lower rack (e.g. plates, pans,
bowls), switch on the LOWER RACK
function. If you select the LOWER RACK
function, the upper rack must be empty.
Add a reduced amount of detergent
compared to that which is recommended
for a full load.