Bosch Appliances 9000373507 Dishwasher User Manual


  Open as PDF
of 22
 


The dishwasher requires soft water to ensure proper washing results.
Your appliance is equipped with an internal water softening system.
However, if you have a household water softening system, you will not
need to use this softening system.
The required amount of salt depends on the degree of hardness of your
tap water (See table for more information).
For the water softening system to function properly, it will need to use
dishwasher water softener salt .The amount of salt dispensed can be set
H:00H:07
.
Open the door (for hidden controls only).
Turn the unit on using the  ON/OFF button .
 ASTART button until the display
H:00
Release both buttons. 
Press  “B” to select the desired setting.
To change the setting,
 C
Save the selected language by pressing the  START button.
Close the door (for hidden controls only).
      
provided in the detergent sample kit, please see below.
Dishwasher setup
 
 
 
   
  
  
  
  
  
  
  

6

0 0 no
1 0 no
2 2 yes
3 4 yes
4 6 yes
Fill with Salt
Fill salt into the salt
container
Dip briefly the test strip into tap water for one
second, shake off excess water compare after 1
min.
Establishing the water
hardness
After one minute the red
dicoloration of the test
areas will show you the
correct setting.
Setting of
Water
Alignment of
Softening

-
ond. Shake off excess water and compare after
approx. 1 minute.
After 1 minute the red
discoloration of the test
areas will show you the
correct setting.
 previous next