Filter
Top Products
9
DOOR PANEL INSTALLATION
SHU/SHE Models - Accessory Panel Installation
If you have an SHU/SHE model and have ordered an
accessory panel kit, install the panel prior to sliding the
dishwasher into place. The panel dimensions are shown in
Figure 15.
SHI Models - Panel Installation
SHI models come with additional mounting hardware and
a template sheet with installation instructions. The stain-
less steel models of the SHI series also come with two
extension pieces. The extension pieces are used to
match the control panel height (Figure 16, “B” dimension)
to the horizontal drawer line of the cabinets, and must be
installed as shown in on the template sheet. The standard
piece is used for drawer heights up to 6” (152mm); the
long piece is used for drawer heights greater than 6”
(152mm) but 6-7/16” (164mm) or less. If your drawers are
taller than 6-7/16”, you can either slide the extension
piece in as far as it will go, or remove it and fit the door
panel directly below the control panel.
SHI/SHV Models - Panel Installation
SHV models come with additional mounting hardware and
a template sheet that will show you how to mount the
panel. One side of the template shows how to mount a
one piece panel; the other side shows how to mount a two
piece panel. Decide which type of installation you want
before proceeding with the installation.
Figure 16
Figure 17
Figure 15
Door Panel Installation
Fig. 16
Dimension
SHI Only
Extension “A”
Max. - Min.
“B” “C”
Max.-Min.
Standard
Long
5/16 - 11/16”
(8-18mm)
11/16 - 1 1/8”
(18 - 29mm)
5 5/16”
(135mm)
5 5/8 - 6 7/16”
(143 - 164mm)
Fig. 17
Dimension
D (SHI)
E
(SHI & SHV)
F
(SHI & SHV)
20 11/16” - 25”
(526mm - 635mm)
27 3/16” - 30 5/16”
(690mm - 770mm)
23 3/16” - 23 3/8”
(589mm - 594mm)
Panel Dimension
25”
(636 mm)
23-1/16”
(586 mm)
1/4” max.
(6 mm)