Filter
Top Products
6
ELECTRICAL PREPARATION
Dishwasher Electrical Rating
A sV zH s
1 0
6 2
stlo tre erepm ttaW
02 1
054,1
)xam(
Figure 4
21"
(533mm)
30"
(762mm)
3/8" - 1/2"
(10mm - 13mm)
3" - 4"
(76mm - 102mm)
Figure 5
Electrical Preparation
Avoid Electrical Shock Hazard
Do not work on an energized circuit. Doing
so could result in serious injury or death.
Only qualified electricians should perform
electrical work. Do not attempt any work on the
dishwasher electric supply circuit until you are
certain the circuit is de-energized.
Electrical Supply
The customer has the responsibility of ensuring that the
dishwasher electrical installation is in compliance with
all national and local electrical codes and ordinances.
The dishwasher is designed for an electrical supply of
120V, 60 Hz, AC, connected to a dishwasher-dedicated,
properly grounded electrical circuit with a fuse or breaker
rated for 15 amps. Electrical supply conductors shall be
a minimum #14 AWG copper wire rated at 75°C (167°F)
or higher.
Regardless of where the electrical supply cable enters
the enclosure, position the cable 21” (533mm) from the
enclosure’s left side, as shown in
Figure 4. Extend the
cable 30” (762mm) from the enclosure’s back, as shown
in Figure 4.
Remove 3” - 4” (76mm - 102mm) of the cable’s outer
casing, as shown in Figure 5, then remove 3/8” - 1/2”
(10 - 13mm) of insulation from each wire, as shown in
Figure 5.
Avoid Fire Hazard
Make sure electrical work is properly installed.
Only qualified electricians should perform
electrical work.
WARNING
WARNING