Filter
Top Products
English 2
• CAUTION: This unit is approved for use with residential appliances. For gen-
eral residential kitchen ventilating use only. DO NOT use to exhaust hazard-
ous or explosive materials or vapors. Vent unit to the outside.
• To reduce the risk of fire or electric shock, do not use the fan with any solid-
state speed control device.
• This appliance has been found to be in compliance with UL507 Standard for
Electric Fans and CAN/CSA-22.2 No. 113 Canadian Standard for Fans and
Ventilators. It is the responsibility of the owner and the installer to determine if
additional requirements or standards apply in specific installations.
Before You Begin
Tools and Parts
Needed
1. Metal Duct Cover (optional)
2. Ductwork as necessary (style varies)
3. Duct Tape
4. Phillips Head Screwdriver
5. Drill with 1/4” bit (6 mm)
6. Tape Measure
7. Screwdriver
Parts Included 1. Chimney sections (2)
2. Filter
3. Hood
4. Transition
5. One Way Damper
6. Screws, 5x60 (6)
7. Sheet Metal Screws, 3.9 (2)
8. UX6 plugs (6)
9. Positioning Templates (2)
If parts are missing or damaged, call the number or write to the address listed
inside the front cover.
General Information The hood is equipped with an internal blower. It is not designed for use with a
remote blower.
Hood installation height above cooktop is the user’s preference. The lower the
hood above the cooktop, the more efficient the capturing of cooking odors,
grease, and smoke. This hood has been approved for installations as low as 30”
(760 mm) and as high as 36” (900 mm) above the cooktop. The lower height may
be inconvenient for tall people and large cooking vessels.
In addition, the chimney sections, when fully extended, measure 42 3/4” (1090
mm) tall. In order for the upper chimney section to meet the ceiling (or surface
above), the highest allowable ceiling height is 9 1/2’ (3 m)(assumes the hood is
installed 36” (900 mm) above the cooktop).
Installation