Filter
Top Products
Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips Consumer Support
Using the surface units. GEAppliances.com
Throughout this manual, features and appearance may vary from your model.
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both OFF and HI the control clicks
into position. You may hear slight
clicking sounds during cooking,
indicating the control is keeping the
power level you set.
A HOT COOKTOP indicator light will glow
when any radiant element is turned on,
and will remain on until the surface is
cooled to approximately 150°F.
Indicator light will:
■ come on when the unit is turned on or hot to
the touch.
■ stay on even after the unit is turned off.
■ glow until the unit is cooled to approximately
150°F.
Be sure you turn the control knob to
OFF when you finish cooking.
Dual Surface Unit Control Knob
The right front surface unit has 2 cooking sizes to
select from so you can match the size of the unit
to the size of the cookware you are using.
To use the small (6-inch) surface unit,
turn the control knob to the SMALL
BURNER settings.
To use the large (9-inch) surface unit,
turn the control knob to the LARGE
BURNER settings.
7
Using the Warming Zone
The WARMING ZONE, located in the back
center of the glass surface, will keep hot,
cooked food at serving temperature.
Always start with hot food. Do not use
to heat cold food. Placing uncooked or
cold food on the WARMING ZONE could
result in food-borne illness.
Push and turn the control knob to any
desired setting.
For best results, all foods on the
WARMING ZONE should be covered with
a lid or aluminum foil. When warming
pastries or breads, the cover should be
vented to allow moisture to escape.
Always use pot holders or oven mitts
when removing food from the WARMING
ZONE, since cookware and plates will be
hot.
CAUTION: Do not warm food on the
WARMING ZONE for more than two hours.
NOTE: The surface warmer will not glow red like
the cooking elements.
A HOT surface indicator light will glow
when the glass surface is hot and will
remain on until the surface is cool
enough to touch. Lower settings may not
heat the glass surface enough to cause the
HOT surface indicator light to come on.
A WARMING ZONE indicator light will
glow when the unit is on.
■ Do not use plastic wrap to cover food. Plastic
may melt onto the surface and be very difficult
to clean.
■ Use only cookware recommended for
top-of-range cooking.
WARMER GUIDE
SETTING FOOD
(Low) Bread/Pastries
(Medium) Chocolate/Butter
(Medium) Sauces, Stews,
Cream Soups
(Medium) Vegetables
(High) Soups (liquid)
(High) Tea or Coffee
The Warmer Guide is for reference
only and the SETTING that you
need will depend on the amount
and type of food, the starting
temperature of the food and the
length of the holding time.