Filter
Top Products
STEP6
INSTALLTHE DOWNDRAFTUNIT
Remove the
downdraft unit
from the
packaging.
Remove the two
screws from the
front of both
vertical edges of
the downdraft
unit. Position the
downdraft stability brackets with the top edges
overlapping the countertop so that the holes
in the brackets align with the holes in the
downdraft unit. Replace the screws. Peel the
backing from the thicker (1/4") of the gasket
strips and apply to the top front edge of the
downdraft unit.
Carefully lower the unit into its position at the
back of the cut-out so that the flanges on the
back edge of the unit and on the two brackets
are fully supporting the unit. Make sure the
downdrafl unit location is all the way to the rear
of the countertop cut-out.
Lift out the downdrafl unit from the countertop
opening.
Remove the blower
(which is supplied
separately as kit
JXDV66) from its
carton and fit the
adapter plate onto
the studs of the
blower housing--
attach with the
washers and nuts
provided.
Fit the blower
assembly onto
the studs of the
downdraft unit,
positioning the
outlet of the
blower in the
required
direction--i.e.,
for left, right or
downwards venting.
Connect the 3 pin plastic plug from the blower to
the 3 pin socket located at the right hand side of
the downdraft unit. Secure the metal cover in
position over the connection. Carefully lower the
downdraft unit and blower assembly into its
position at the rear of the countertop cut-out.
14
STEP7
INSTALLINGTHE COOKTOP
Remove all packaging material from the cooktop.
Position the cooktop over the cut-out opening
and carefully lower it into place, making sure
that the power cord is dropped into the cabinet.
Make sure the cooktop location is all the way to
the front of the countertop cut-out. Lift out the
cooktop from the countertop opening.
Cut one of the remaining gasket strips in half
(these are to be used as the side strips). Peel
the backing from the self adhesive gasket strips,
and apply the gaskets to the underside of the
glass, as close as possible to the edge without
protruding, ensuring the side strips end at least
3/8" from the back edge.
1/16--'-f/,-..
The weight of the cooktop will cause the gasket
to form a watertight seal with the countertop.
Position the cooktop over
the cut-out opening and
lower into place, making
sure that the power cord is
dropped into the cabinet.
Press gently and evenly to
firmly seat the unit in the countertop.
NOTE: If the cooktop is installed in a 36 inch
base cabinet, the pressure regulator must be
assembled to the bottom of the cooktop before
the cooktop is placed in the cabinet. Refer to
Step 8.
Slots are provided --_.......
on each side of the
case to accept the
mounting brackets.
Insert bracket into ,4"
the highest available
slot, (depending on
the countertop
thickness), and
secure with the
screws provided.