Filter
Top Products
12
Figure 26
Wait at least ten seconds or until water noises
stop before opening the dishwasher door.
To resume the cycle, press the On/Off button and
shut the dishwasher door.
Canceling or Changing a Cycle
To cancel or change a cycle, press and hold for
three seconds the two buttons labeled “Cancel
Drain” as shown in Figure 26.
For delicate or heirloom dishware and silverware,
or other special items, select Delicate/Econo
after referring to the Materials section of this
manual. Hand-washing may be the best
treatment of such items.
More information on dishwasher cycles is in the
Wash Cycle Information section of this manual.
Starting the Dishwasher
Shut the dishwasher door.
Press the On/Off button.
Press the button for the desired wash cycle.
The dishwasher will start automatically and
continue operating until the end of the selected
cycle.
Once you start the dishwasher, leave the
dishwasher door shut until it finishes the cycle.
Selecting the Proper Wash Cycle
Items with baked-on or hard, dried-on soiling will
require either Power Scrub Plus or possibly
soaking and hand-scouring.
The Regular Wash cycle will thoroughly clean
large loads having loosely attached normal
soiling.
The Rinse and Hold cycle will allow you to keep a
small load in your dishwasher until you have
enough items for a full load.
Operating the Dishwasher
To avoid damage to delicate or heirloom
items do not wash them in your dishwasher.
Interrupting a Cycle
NOTE
: Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
is best to do so within the first 30 minutes of the
cycle.
Press the On/Off button.
You could be seriously scalded if you open
the dishwasher door quickly during a wash
or rinse cycle. Do not fully open the
dishwasher door for at least 10 seconds or
until water noises stop.
Wait approximately one minute, then press the
On/Off button.
You may now begin a new cycle.
Cancel Drain
WARNING