Filter
Top Products
15
Care and Maintenance (continued)
To reinstall the top spray arm:
1. Return the top spray arm to its installed
position.
2. Return the locking nut to its installed
position and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller
guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the
dishwasher tub.
2. Grasp and lift the bottom spray arm as
shown in Figure 29.
Figure 29
Figure 30
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed
position and press it so that it snaps into
place.
2. Return the bottom rack to its installed
position.
Check/Clean the Filter System
Your Bosch dishwashers has a filter system that
is made up of a Large Object Trap/Cylinder Filter
assembly and a Fine Filter. The filter system is
located on the dishwasher floor and is easily
accessible.
During normal use the filter system is self-
cleaning, but you should occasionally inspect it
for foreign objects and clean it when necessary.
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, flush
them under running water.
Figure 31
Large
Object Trap
Cylinder
Filter
Assembly
To remove the Large Object Trap/Cylinder
Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 30,
and turn it counterclockwise 1/4 turn.
3. Lift out the assembly as shown in Figure
31.
To avoid injury, do not reach into the large
object trap with your fingers. The large
object trap could contain sharp objects.
4. Carefully examine the assembly. If you find
debris in the Large Object Trap, turn it
upside-down and gently tap it on a surface
such as a countertop to dislodge and
remove the debris. Flush the Cylinder Filter
clean by holding it under running water.