Filter
Top Products
15
To remove the bottom spray arm:
1. Remove the empty bottom rack from the dishwasher tub.
2. Grasp and lift the bottom spray arm as shown in Figure 27.
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, ush them under running water.
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed position and press it so that it snaps into
place.
2. Return the bottom rack to its installed position.
Check/Clean the Filter System
This dishwasher has a lter system that consists of a Large Object Trap/Cylinder Filter
assembly and a Fine Filter. Select models have an additional Micro Filter. The lter system is
located on the inside of your dishwasher under the lower rack and is easily accessible.
During normal use, the lter system is self-cleaning. You should occasionally inspect it for
foreign objects and clean it when necessary.
CAUTION
To avoid injury, do not reach into the large object trap with your ngers. The large
object trap could contain sharp objects.
This dishwasher has a lter system that consists of a Large Object Trap/Cylinder Filter
assembly and a Fine Filter. The lter system is located on the inside of your dishwasher
under the lower rack and is easily accessible.
During normal use, the lter system is self-cleaning. You should occasionally inspect it for
foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 28 and turn it counter-
clockwise 1/4 turn.
3. Lift out the assembly as shown in Figure 29.
4. Carefully examine the assembly. If you nd debris in the Large Object Trap, turn it
upside-down and gently tap it on a surface such as a countertop to dislodge and
remove the debris. Flush the Cylinder Filter clean by holding it under running water.
To Remove the Fine Filter:
1. Lift the Fine Filter from the dishwasher oor as shown in Figure
30 A and ush it clean by holding it under running water.
2. Remove the Micro Filter as shown in Figure 30 B and ush it clean by holding it under
running water.
To reinstall the lter system:
1. Return the Fine Filter to its installed position.
2. Place the Large Object Trap/Cylinder Filter Assembly into its installed position in the
dishwasher oor.
3. Turn the ring handle clockwise 1/4 turn until it is locked. The arrow
on the ring handle and the arrow on the Fine Filter should point to each other, as
shown by the circle in Figure 31.
4. Gently pull the ring handle to ensure that the assembly is locked into place.
ATTENTION
To avoid possible diswasher damage, do not use harsh chemicals, abrasive cleaners,
scouring pads (metal or plastic), or abrasive cloths/paper towels to clean your dish-
washer’s exterior door panel. Your dishwasher’s exterior door panel can be damaged
by doing so.
Figure 29
Figure 30
Figure 31
Large Object Trap/Cylinder Filter
Fine
Filter
Micro
Filter
To close - turn clockwise.
A
B