Filter
Top Products
Preparing your machine for use
4 Preparing your machine for use Preparing your machine for use 5
PLEASE NOTE:
• This appliance is intended for household use only.
• Place the appliance on a dry, flat and fixed surface
and keep it out of reach of children.
• Never use warm water, sparkling water or milk to fill
the water container.
• Never open the brew mechanism during brewing.
In “Auto Mode”, always wait for the indicator light
to move from AUTO to MANUAL before opening the
brew mechanism. In “Manual Mode”, take your
finger off the start/stop button and wait until the
machine has stopped before opening the
brew mechanism.
• For some drinks, the brew cycle includes a 10 second
pause after the initial influx of water. This pause is
normal and allows the water to fully saturate the
product before brewing continues.
• If during brewing you can hear the machine running
but no drink is produced, stop the cycle by pressing
and releasing the start/stop button. Open the
brew mechanism carefully and slowly, and discard
the T-DISC. Try again with a fresh T-DISC.
• After 10 minutes of non-use, the STANDBY light
will illuminate. If you are not going to use your
machine for an extended period, turn it off using
the on/off switch.
• Braun electric appliances meet applicable safety
standards. Repairs on electric appliances (including
cord replacement) must only be carried out by
authorised Braun service centres. Faulty, unqualified
repair work may cause accidents or injury to the user.
• This machine is not suitable for use at altitudes
above 2000 meters.
Rinse the water container, fill it to “max” with fresh
cold water and place it on the machine. Check that the
water container is inserted in the slot of the back of the
machine. Connect the machine to the electrical supply
and press the on/off switch located on the back of the
machine. All the indicator lights will flash. Place a large
cup (at least 200ml) on the adjustable cup stand.
Open the brew mechanism, position the cleaning
disc on the T-DISC holder, bar code facing down.
Firmly close the brew mechanism by pressing the
clamp down until it shuts.
Wait five seconds then press and release the start/
stop button to start the machine. You will hear the
machine run for a short period to fill the internal water
heater. When the machine stops running, the STANDBY
light will illuminate.
Open the brew mechanism and close it again leaving
the cleaning disc in place. The orange HEATING light
will begin to flash. Wait about a minute until the green
AUTO light illuminates then press and release the
start/stop button. The machine will fill the cup with
water. When the machine stops running, empty the cup
and place it back on the adjustable cup stand. Repeat
this step in its entirety.
Open the brew mechanism and remove the cleaning
disc. The HEATING light will illuminate. Do not discard
the cleaning disc after use – you will need it for flushing
and descaling the appliance. Your machine is now ready to
IMPORTANT
Before using your Tassimo machine for the first time, you must
prepare it by following the procedure below.
Your Tassimo machine comes
with a cleaning disc to use for rinsing and descaling the machine.
KRA585(UK) User Guide.qxd 10/14/04 2:32 PM Page 8