Filter
Top Products
How to use the machine – Auto Mode
6 How to use your machine – Auto Mode How to use your machine – Auto Mode 7
Rinse and fill the water container with fresh cold water. Turn on
the machine by pressing the on/off switch. Open the brew
mechanism. Opening the brew mechanism will initiate the
heating of the water and the HEATING light will flash.
Place a clean cup on the cup stand, adjusting the height of the
stand up or down so that the rim of the cup is close to the
brew mechanism.
Position your choice of T-DISC on the T-DISC holder, label facing
down. Firmly close the brew mechanism by pressing the clamp
down until it shuts. The HEATING light may flash again as the
machine heats the water to the required temperature for
your drink.
When the AUTO light illuminates, press and release the start/
stop button. Brewing will start automatically. There may be
a short pause during brewing; this is normal. The AUTO light
flashes throughout the brew cycle. When the machine has
finished brewing, the indicator light will move from AUTO to
MANUAL and then, after a delay of 30 seconds, to HEATING.
• When the indicator light moves to MANUAL, you can customise
your cup as described in “Manual Mode” (See page 8).
• At any time during the “Auto Mode”, you can stop the brew cycle
by pressing and releasing the start/stop button. The machine
will stop and any remaining liquid inside the T-DISC will empty
into the cup.
Open the brew mechanism, remove the T-DISC and discard.
Your drink is now ready to be enjoyed.
You can prepare the next beverage right away by repeating
steps 2 – 5.
• Always remove the used T-DISC from the machine right after
brewing. When removing the T-DISC, handle it by the thumb
tab to avoid contact with heated areas.
• Please ensure that there is enough water in the water
container. If the water level is too low, all the indicator lights
will flash, signalling that the water container needs to
be refilled.
• To adjust the cup stand, insert your finger in the centre
of the stand, lift and turn.
• To avoid spilling over, please choose the right sized cup for
the drink you are making. See page 3 “Tips for the Perfect Cup”.
KRA585(UK) User Guide.qxd 10/14/04 2:32 PM Page 10