Filter
Top Products
CARE AND CLEANING OF YOUR BLENDER
Blender container parts are corrosion resistant, sanitary and easily
cleaned. Before first use and after every use, separate container
p
arts and clean thoroughly in warm, soapy water, then rinse and
dry well.
DO NOT WASH ANY PARTS IN AN AUTOMATIC
DISHWASHER.
Periodically check all parts before re-assembly. If the processing
blades are stuck or difficult to turn,
DO NOT USE BLENDER.
Check by carefully turning the blades in a counter clockwise
direction (opposite edges are sharp). Blades should turn freely. If
the glass container is chipped or cracked
DO NOT USE
BLENDER. Further use could result in the container breaking
during use. Use only Bravetti recommended replacement parts
available at an authorized service facility or the factory.
USE OF
DAMAGED OR
NON-RECOMMENDED PARTS COULD
RESULT IN SEVERE PERSONAL INJURY
AND/OR
DAMAGE TO THE BLENDER.
NEVER IMMERSE THE MOTOR BASE IN WATER.
The
housing can be cleaned with a damp cloth (unplug first). The motor
is permanently lubricated and does not require any additional
lubrication.
ANY SERVICING SHOULD BE PERFORMED
BY
AN AUTHORIZED SERVICE FACILITY.
7
CAUTION: BLADES ARE SHARP. HANDLE
CAREFULLY.
CAUTION: NEVER PLACE BLENDER MOTOR
BASE OF APPLIANCE IN WATER OR
OTHER LIQUIDS.
1.
Immediately after each use, disassemble lid and cutting
assembly. Carefully wash all parts in warm soapy water.
Rinse and dry thoroughly. Do not wash parts in
dishwasher.
2.
Do not use a harsh abrasive on any part of the blender.
3.
Clean the exterior of blender motor base with a soft
damp cloth and dry.
4.
Reassemble cutting assembly onto container. Place onto
blender motor base with lid assembly. Spin dry on
HIGH for 10 seconds.
Any servicing requiring disassembly other than the above cleaning
must be performed by an authorized service center. Failure to
follow this instruction may result in a fire, electric shock or injury
to persons.
CARE AND CLEANING STEPS
1.
Push the OFF button and unplug the appliance.
2.
Grasp container handle and lift container from the
blender motor base. Rinse with water to remove any
large food particles that may have accumulated in the
container.
3.
Reposition the container into the blender motor base.
4.
Add 1 1/2 cups warm, soapy water to the container and
cover with the lid assembly.
5.
Push one of the low settings for a few seconds.
6.
Touch the OFF position and unplug the appliance.
7.
Grasp container handle and lift container off of the
blender motor base. Remove lid and assembly and rinse
container with water. Repeat steps 1-7 as necessary.
8.
Unscrew collar from container and remove cutting
assembly.
8