Bravetti CM80H Coffeemaker User Manual


  Open as PDF
of 6
 
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Control Panel Features
Familiarize yourself with the control panel
before using your coffee maker.
Fig. 1
1
2
3
4
5
6
7
8
9
7. Advanced Timer Indicator Light
This timer indicates that the coffee
maker is in a delayed brewing cycle.
To verify what time the brew cycle will
begin depress the advanced timer
button.
8. Power “On” Indicator Light
This light indicates that the unit is
turned on.
9. Brew Strength Indicator Light
This indicator lights up when the brew
strength feature has been selected for
brewing.
How to Set the Clock
When the unit is first plugged in, the
display will read 0:00 and begin to flash.
To set the correct time of day:
1. Press and hold the set hour button until
the correct hour is displayed.
2. Press and hold the set minute button
until the correct minute is displayed.
NOTE
: Unplugging the unit will reset the
clock to “0:00” and flashing will resume.
Preparing Your Coffee Maker
Before using the coffee maker for the first
time:
1. Carefully unpack the coffee maker and
remove all packaging materials.
2. Thoroughly clean the carafe, carafe lid,
and filter basket with warm, soapy
water. Rinse well and dry.
CAUTION
: Do not use harsh or abrasive
cleaners as this could damage the glass
carafe.
3. Wipe the warming plate with a clean
damp cloth.
WARNING
: DO NOT immerse the coffee
maker in water or other liquids.
4. Before brewing your first pot of coffee,
run a full carafe of cold water through
the system 2 or 3 times, without a filter
or coffee grounds. This will remove any
dust or sediment that may have settled
in the components during the shipping
process.
Using the Coffee Maker
Select a level, flat surface to place the
coffee maker, preferably near an outlet.
1. Replace the lid after cleaning and
ensure that it is secured to the carafe.
2. Replace the filter basket into the filter
basket compartment.
3. Lift up the hinged water reservoir cover.
4. Fill the glass carafe with as much water
as is needed for the amount of
servings.
5. Empty the water from the carafe into
the illuminated water reservoir. The
water window indicates how much
water is in the reservoir. (Fig. 2)
6. Close the water reservoir cover.
7. Place the glass carafe with the lid in
place onto the warming plate.
CAUTION
: The small opening at the rear
of the illuminated water reservoir prevents
accidental overflow of coffee into the filter
and or carafe. Do not
overfill the
illuminated water reservoir.
Putting in the Coffee
1. Press the filter basket door release
button and insert a #4 cone shaped
paper filter into the filter basket.
2. Fill the filter with the required amount of
coffee depending on amount. (Fig. 3)
Fig. 2
Fig. 3
Tip: When you use a paper filter, it is
important that the filter fit flush against the
sides of the filter basket. If the filter
collapses, for best results, dampen the
filter before placing it in the filter basket
and adding the ground coffee.
3. For best results use coffee that is
ground for use with automatic drip
coffeemakers. (See chart below for
suggested amounts)
4
1. Digital Clock/Advance Timer
Display
A 24 hour clock display and display for
the advance timer feature.
2. Set Hour Button
This button allows you to set the clock
for the hour time and to pre-program
the coffee maker’s advance timer hour.
3. Set Minute Button
This button allows you to set the clock
for the minute time and to pre-program
the coffee-maker’s advance timer in
minutes.
4. Advance Timer Button
This button programs the coffee maker
up to 24 hours before the desired
brewing time. Hold down this button
while adjusting the time – hour and
minutes to begin the advance timer
action.
5. Brew Strength Button
The brew strength button is used to
enhance the flavor of the coffee.
6. Auto/Power “On” Button
This button controls three modes:
A. Auto Mode
Depress this button once to activate
the Auto Mode. Use to set the
advance timer.
B. Power “On” Mode
Depress twice to activate the
Power “On” Mode. This begins the
brew cycle immediately.
C. Power “Off” Mode
Depress three (3) times to activate
the Power “Off” Mode. This shuts
off the unit completely, including the
warming plate.
One Cup = Five ounces brewed coffee
1.52
34
46
68
710
912
TABLESPOONSNUMBER OF CUPS
4. Swing the filter basket door closed until
it snaps into place.
CAUTION
: Do not operate your coffee
maker if the door does not close
completely. If the door does not close
completely, check to see that the filter
basket is properly seated, and snap the
door back into place.
5. Depress the auto/power button twice
(2x) to activate the brew cycle.
Advance Timer Mode
1. Press and hold the advance timer
button, while continuing to hold the
advance timer button– press the set
hour button until the desired brew time
hour is displayed.
2. Press the set minute button until the
desired minute has been displayed.
3. Release the advance timer button.
4. Press the auto/power button once, the
advance timer “On” indicator light will
illuminate. This indicates that the coffee
maker is waiting for the preset brew
time to be reached before it will begin
the brew cycle.
CAUTION
: If the auto/power “On” button
is pressed before the advance timer
button, the advance timer mode will not
activate.
5
 previous