Filter
Top Products
21
TROUBLESHOOTING
POSSIBLE PROBLEM EASY SOLUTION
Machine will not work
when turned ON.
The Safety Locking Arm may not be correctly engaged in the
vertical operating position with the locking arm located into
the two grooves on either side of the Juicer Cover
Motor appears to stall
when juicing.
Wet pulp can build up under the juicer cover if the juicing
action is too vigorous. Try slower juicing action by pushing
the food pusher down slower. Follow Disassembling and
Cleaning instructions and clean the filter bowl surround, the
stainless steel filter basket and the juicer cover.
Hard fruit and vegetables will put excess strain onto the
motor if a low speed is selected. Please refer to the juicing
guide to determine the correct speed for the fruit and
vegetables selected for juicing.
Excess pulp building
up in the Stainless
Steel Filter Basket.
Stop the juicing process and follow Disassembling
instructions. Remove the juicer cover, remove pulp,
reassemble and begin juicing again. Try alternating soft and
hard vegetables and fruit varieties
Pulp too wet and
reduced
extracted juice.
Try a slower juicing action. Remove the Nutri Disc™ and
thoroughly clean mesh walls with a cleaning brush. Rinse
the filter basket under hot water. If the fine mesh holes are
blocked, soak the basket in a solution of hot water with 10%
lemon juice to unlock the holes or wash in the dishwasher.
This will remove excess fiber build up (from fruit and
vegetables) which could be inhibiting the flow.
Juice leaks between
the rim of the Juicer
Cover and the juicer.
Try a slower juicing speed and push the food pusher down
the feed chute slower.
The unit will not turn
on.
Check the Overload Protection Button on the bottom of the
Motor Base to insure the safety device has not been activated
automatically.