Filter
Top Products
8
9
ASSEMBLING YOUR BREVILLE 800 CLASS™ CITRUS PRESS
ASSEMBLING YOUR BREVILLE 800 CLASS CITRUS PRESSASSEMBLING YOUR BREVILLE 800 CLASS CITRUS PRESS
Step 1.
Pull the Juicer Press Arm up and backwards,
away from the Motor Base, until fully extended.
Step 2.
Place the Juice Collector onto the Drive Shaft
on top of the Motor Base. Ensure the Juice
Spout fits into the semi-circular groove
at the front of the Motor Base.
Step 3.
Insert the selected Stainless Steel Filter (fine
or coarse) into the Juice Collector, aligning
the indent with arrow in the bottom of the
Filter over the corresponding tab with arrow
in the Juice Collector. Use the Coarse Filter for
maximum pulp content in the juice and the Fine
Filter to decrease the pulp content in the juice.
Step 4.
Place the Juicing Cone onto the Drive Shaft
and press down lightly to lock the Cone
into position.
Step 5.
Insert the Fruit Dome onto the underside of the
Juicing Press Arm by aligning the tab on top of
the Fruit Dome with the hole in the Juicing Press
Arm. Hold onto the Juicing Press Arm and press
the Fruit Dome up and backwards until the
Dome locks into position. Note: The Fruit Dome
is keyed, and can only be inserted in one way
(this will ensure that it does not rotate
through operation).
Step 6.
Ensure the Anti-drip Juice Spout is pushed down
into the pouring position.
Step 7.
Place a suitable sized glass or jug underneath
the Juice Spout.