Filter
Top Products
13
12
OPERATING YOUR BREVILLE 800 CLASS CITRUS PRESSOPERATING YOUR BREVILLE 800 CLASS CITRUS PRESS
Step 7.
Remove the used fruit from the Juicing Cone.
Empty excess pulp and seeds from Stainless
Steel Filter as required.
Repeat Steps 3-7 to continue juicing.
Step 4.
Place a citrus fruit half, cut side down, onto
the Juice Cone and push down lightly onto
the spikes
Step 5.
Grasp the Soft Grip Handle and slowly lower the
Juicing Press Arm and press down firmly until
the Fruit Dome is in contact with the fruit skin.
The motor will automatically start and the
Juicing Cone will begin to rotate. The juice will
be extracted from the fruit and flow through the
Juice Spout into the glass, The pulp and seeds
will collect in the Stainless Steel Filter.
Step 6.
The 800 Class Citrus Press juices very quickly so
each fruit half will be juiced in a few seconds.
To automatically stop the motor, lift the Juicing
Press Arm up and backwards to its extended
position.
NOTE: The Stainless Steel Filter should
be emptied when full with pulp
and seeds. The Filter can be
emptied during juicing by
switching the Citrus Press "OFF"
at the On/Off button and
carefully removing the Juicing
Cone and Filter. Clean and
replace Stainless Steel Filter and
Juicing Cone before continuing
to juice.
Do not allow the Stainless Steel
Filter to overfill as this may
prevent correct operation or
damage the unit.