Filter
Top Products
6
USING YOUR WATER FILTER/CHILLER
1. Lift the hinged lid and using a
suitable jug, carefully pour water into
the tank up to the MAX FILL LEVEL.
This may take some time due to the
action of the filter.
2. Keep adding water until all the tanks
are full. Water flows through the
cartridge at a set rate. This is to
achieve the best possible filtration.
Because of this it may take some time
to fill all the tanks on first use. During
normal use top up the tanks regularly.
3. Close the hinged lid.
4. Plug the unit into the mains supply.
Press the chiller ON/OFF switch on
the front of the unit. The switch will
illuminate and the machine will begin
to chill the water.
5. Dispense 2 litres of water from the
unit to remove any unfiltered water
from the unit that was used to prepare
the chiller as instructed on page 4.
6. Within approximately 3 hours the blue
indicator on the front of the unit will
light indicating that the water has
chilled to approximately 10
O
C,
although this may take longer in very
hot weather. The indicator will cycle
on and off as the unit maintains its
temperature, but the unit will continue
to chill the water down to 8
O
C then
stop. If the water temperature rises
above 8
O
C the unit will start to chill
again.
We recommend that the water chiller
be kept out of direct sunlight and away
from any heat source.
7. Place a glass under the dispenser
and push the lever back to dispense
water.
8. Top up the water tank as necessary.
✎✎
✎✎
✎ NOTE
It is normal for the indicator to go off
when water is drawn. Water inside
the unit will remain chilled but the
indicator will not come on again until
the optimum temperature has been
reached.
✎✎
✎✎
✎ NOTE
After filling, it is important to vent any
air in the unit otherwise the chiller will
not function correctly. Do this by
pressing the dispensing lever until
the water flows from the dispenser
without any air bubbles present. Once
the water is clear of any air bubbles,
the dispensing lever may be released.
Top up the water tank if necessary.