Filter
Top Products
9
NOTE:
In order to remove any excess
protecting oils from the Burr
Grinder, it is necessary to grind
1.75 oz (50g) of coffee beans on
the Extra Fine (Espresso) setting.
Discard this initial ground coffee.
NOTE:
Adjust the fineness of the grind
only when the grinder is in
operation or when there are no
beans in the hopper.
8. Rotate the Timer Selector Dial to select
the desired grinding time.
9. Press the ‘START’ button on the front of
the Grinder to begin grinding. The Coffee
Grinder will begin grinding the coffee
directly into the Grinds Container and
will stop automatically when grinding is
complete. To stop the grinding cycle at
any time, push the ‘START’ button again.
If the ‘START’ button is pressed again,
the grinder will start from the beginning
of the timed cycle.
10. Remove the plug from the power outlet.
11. Gently tap the side of the Grinder, above
the Grinds Container, so that any grinds
remaining in the grinding chute are
released into the Grinds Container.
12. Remove the Bean Hopper, Bean Hopper
Lid and Grinds Container and wash in
warm soapy water with a soft cloth.
Rinse and dry thoroughly.
13. Wipe the Grinding Chamber with a soft
dry cloth and replace the Bean Hopper,
Bean Hopper Lid and Grinds Container
back into position.
14. Rewind the power cord into the
cord storage area located under the
Grinder base.
OPERATING
your Breville Conical Burr Grinder™
OPERATING YOUR BREVILLE CONICAL BURR GRINDER™
Before first use
Before first use, remove any promotional
stickers or packaging material attached to
your Grinder.
1. Remove the Bean Hopper, Bean Hopper
Lid and Grinds Container and wash in
warm soapy water with a soft cloth. Rinse
and dry thoroughly. Before each use,
ensure Grinding Chamber and Grinds
Container are clean and empty.
2. Remove the Burr Grinder inside the
Grinding Chamber by gripping the small
inner black plastic frame and pulling out
the top ring.
3. Using a soft cloth, wipe off any excess
protecting oil from the Burr Grinder and
place it back into the Grinding Chamber.
4. Place the Bean Hopper into the Grinding
Chamber so the ‘ALIGN’ arrow on the
Bean Hopper aligns with the ‘ALIGN’
arrow on top left-hand side of the Grinder.
Turn the Bean Hopper clockwise to lock
into position.
5. Measure the desired quantity of whole
coffee beans or spices directly into the
Bean Hopper and cover with the Bean
Hopper Lid.
6. Plug the Grinder into a 110/120V
power outlet.
7. To select the desired fineness of grind,
rotate the Bean Hopper and align the white
marker on the front panel of the Grinder
with one of the following settings:
COARSE – French Press
MEDIUM – Percolator/Drip Filter
FINE – Espresso
(Dual Wall Filters)
EXTRA FINE – Espresso
(Single Wall Filters)
See Coffee Chart on page 10 for
additional coffee setting recommendations.
BCG450XL_IB_C10.indd 8-9 30/08/10 9:51 AM