Filter
Top Products
11
OPERATING YOUR BREVILLE PRODUCT
OPERATING
your Breville product
BEFORE FIRST USE
Remove any promotional material attached
to your kettle. It is recommended that before
first use, the kettle is filled to the maximum
level with cold tap water, boiled and water
discarded. Your kettle will only operate
when positioned on the power base with the
On/Off switch in the On position. The kettle
will automatically switch off once the water
has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle, remove it from the power
base and open lid by pressing the lid release
button. Fill with the desired amount of water.
NOTE
Always fill the kettle between the
minimum (500ml) and maximum
(1700ml) marks on the water window.
Too little water will result in the kettle
switching Off due to the safety boil dry
protection. Filling above the maximum
mark (MAX) may result in boiling
water splashing from the kettle.
Ensure the lid is locked firmly into place.
Position the kettle securely onto the power
base. Insert the power plug into a 230/240V
power outlet and switch on.
Press the On/Off switch to the On position
for water to boil. The power On light will
illuminate.
NOTE
This kettle must only be used with
the power base supplied. Use caution
when pouring water from your kettle,
as boiling water will scald. Do not
pour the water too quickly.
The kettle will automatically switch Off once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled
to the maximum level. To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
If further heating of the kettle is not
required, switch Off at the power outlet,
unplug the power cord and empty the water
from the kettle. Replace the kettle onto the
power base and close the lid.
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the
appliance be operated with insufficient water.
If this occurs, the kettle will stop. Press the
On/Off switch to Off position, switch Off
at the power outlet and allow kettle to cool
before refilling. Remove the kettle from the
power base and add water. Return the kettle
to the power base. The safety device will then
automatically reset.
For additional safety, your kettle is fitted
with thermal cut out. In the event of
overheating, the kettle will automatically
shut down to prevent further damage.
Should this occur, take your kettle to an
authorized Breville Service Centre.
WARNING
The appliance is designed for boiling
of drinking quality water only. Never
use to heat or boil any other liquids
or foodstuffs. The lid should always
be firmly in place and locked into the
closed position before use.
WARNING
Do not press the lid release button on
the handle to open the lid during and
after operation. This may result in
boiling water splashing from the kettle.
Pour out all the hot water from the
kettle before opening the lid to refill.