Filter
Top Products
13
OPERATING YOUR BREVILLE PRODUCT
OPERATING
your Breville product
BEFORE FIRST USE
Remove and safely discard any packaging
material or promotional labels attached to
your kettle. It is recommended that before
first use to fill the kettle to the maximum
level with cold tap water, bring to the boil by
selecting the BOIL 100° button, then discard
the water. Your kettle will only operate when
positioned on the power base. The kettle will
automatically switch off when the water has
reached the selected temperature.
OPERATION OF YOUR KETTLE
1. To fill the kettle, remove it from the
power base and open lid by pressing the
lid release button. Fill with the desired
amount of water.
NOTE
Always fill the kettle between the
minimum (500ml) and maximum
(1700ml) marks on the water window.
Too little water will result in the kettle
switching Off due to the safety boil dry
protection. Filling above the maximum
mark (MAX) may result in boiling
water splashing from the kettle.
2. Ensure the lid is closed and locked
firmly into place. Position the kettle
securely onto the power base. Insert the
power plug into a 230/240 power outlet
and switch on. The START/CANCEL
and 100° BOIL button surrounds will
illuminate in white for one minute.
A beep will sound for two seconds.
The START/CANCEL button surround
will automatically switch off after one
minute if not selected.
NOTE
If the START/CANCEL button is
pressed (before selecting a temperature
button), the START /CANCEL button
surround will illuminate in red and the
100º button surround will illuminate
and the kettle will start heating.
3. Select the desired setting by pressing
one of the five temperature buttons
(80°, 85°, 90°, 95°, 100°). The selected
button and the START/CANCEL button
surround will illuminate in white.
NOTE
The KEEP WARM function can be
selected before, during or on
completion of the water heating cycle
(refer page 9).
4. Press the START/CANCEL button and
the surround will illuminate in red, the
selected temperature button surround
will illuminate and the kettle will start
heating. Do not remove the kettle from
the power base during operation. Ensure
the kettle has switched off after the water
has boiled or the selected temperature
has been reached before removing the
kettle from the power base. If the kettle
is removed from the power base during
the KEEP WARM function the kettle will
automatically switch off.
5. When the kettle has heated the water to
the selected temperature, 3 beeps will
sound, the START/CANCEL button
surround illumination will switch off,
and the selected temperature button
surround will remain illuminated for
1 minute before switching off.