Filter
Top Products
9
OPERATING YOUR BREVILLE TOAST & MELT
BEFORE FIRST USE
Remove any promotional materials and
packaging materials before use. Check that
the cooking plates are clean and free of dust.
If necessary, wipe over with a damp cloth.
When using the sandwich press for the first
time you may notice a fine smoke haze.
This is caused by the heating of some of the
components. There is no need for concern.
TOASTED SANDWICHES
1. Insert the power plug into a 230V or
240V power outlet and then turn the
power ON. The red ‘POWER’ light
will illuminate.
2. Allow the sandwich press to pre-heat
with the top cooking plate in the closed
position until the green ‘READY’
light illuminates.
3. During this time, prepare the sandwich.
When the sandwich press has pre-
heated, place the sandwich onto the
bottom cooking plate. Always place
sandwiches towards the rear of the
bottom cooking plate.
4. Close the top cooking plate. The top
cooking plate has a floating hinge that
is designed to evenly press down on the
sandwich (see Fig 1).
Fig. 1
5. Toasting should take approximately 5-8
minutes. Exact toasting time will be a
matter of taste. It will also depend on the
type of bread and type of filling used.
6. When the sandwich is cooked, use the
handle to open the sandwich press and
raise the top cooking plate. Remove
sandwich with the help of a plastic or
wooden spatula. Never use metal tongs
or a knife as these can cause damage to
the non-stick coating.
NOTE
Always allow the sandwich press to
pre-heat until the green ‘READY’
light illuminates.
NOTE
The safety locking storage clip should
not be used to clamp down the top
cooking plate when the sandwiches
are in the sandwich press. The weight
of the top cooking plate will gradually
press down the sandwich during the
cooking process.
NOTE
When using the sandwich press for
the first time you may notice a fine
smoke haze. This is caused by the
heating of some of the components.
There is no need for concern.
CAUTION
HOT SURFACE - The temperature of
accessible surfaces may be high when
the appliance is operating.
Fully unwind the cord from the cord
storage facility before use.