Filter
Top Products
THE METAL PARTS OF THE FILTER HOLDER MIGHT STILL BE VERY HOT.
COOL DOWN THESE PARTS BY RUNNING UNDER COLD WATER.
TO AVOID POSSIBLE BURNS FROM HOT STEAM AND WATER, NEVER OPEN
THE WATER TANK CAP WHILE THERE IS PRESSURE IN THE WATER TANK.
REMOVE ALL PRESSURE FIRST.
NEVER LET COFFEE OR WATER LEVEL IN A CUP REACH THE POURING
NOZZLE OF THE FILTER HOLDER.
fig 3 fig 4
correct
(level)
Incorrect
(Heaped)
The steam pressure in the
machine must be released
each time BEFORE re-filling
with fresh cold water.
BREWING THE COFFEE
The twin nozzle filter holder allows you to
make either one or two espresso coffees
at a time.
• Make sure the drip tray is in place. Place
empty coffee cups on the drip tray under
the filter holder.
• Make sure the Brew/Steam Selector
Control is in the ‘STANDBY’ position.
• Plug the power cord into a 230/240v
power outlet and switch on.
• The red power ‘On’ light will illuminate
when the appliance has been switched on
at the power outlet and the cup warming
plate will start heating.
• Rotate the Selector Control to the ‘BREW’
position . The orange heating light will
illuminate to let you know the water is
heating. Coffee will begin to flow into the
cups in approximately five minutes.
• The Pressure Indicator Button on the
Water Tank Cap will rise when sufficient
steam pressure is achieved.
• When sufficient coffee has flowed into the
cups, turn the Selector Control back to
the ‘STANDBY’ position. This will stop the
flow of coffee.
• If you are not continuing to using the
steam function, switch off at the power
outlet, unplug the power cord, remove all
pressure and allow the appliance to cool.
• Do not remove the water tank cap or filter
holder until the steam pressure in the
appliance has been released. The
Pressure Indicator Button should drop
down and be flush with the top of the
water tank cap.
OPERATING YOUR BREVILLE ESPRESSO/CAPPUCCINO MAKER
9
PREPARING THE COFFEE
• Remove the filter holder by rotating 45
degrees to the left (Fig 2 ).
• Place the 2 or 4 cup filter into the filter
holder and use the measuring spoon to
fill the filter with ground espresso coffee
to the required cup level marking inside
the filter (use the smaller filter for 1 or 2
cups and the larger filter for 2 or 4 cups).
Do not fill above the 2 or 4 cup mark.
• Distribute the ground coffee evenly and
press it lightly with the measuring spoon
(Fig 3 and 4). Too much coffee can block
the flow of water.
• Clean any excess ground coffee from the
rim of the filter holder to ensure a proper
fit under the brew head.
• Place the filter retainer clip in the release
position by pulling the clip back towards
your hand.
• Place the filter holder underneath the
brew head so that the handle is positioned
to the left of centre. Lift the filter holder
until it contacts the brew head and rotate
to the right.
OPERATING YOUR BREVILLE ESPRESSO/CAPPUCCINO MAKER
8
fig 2