Filter
Top Products
2
CONTENTS
Safety Precautions ................................................................... 2
Model and Serial No. Identification ......................................... 2
Transporting Compactor .......................................................... 2
Manually Raising and Lowering Ram ...................................... 2
Troubleshooting Guide ......................................................3 & 4
Component Replacement ............................................... 5, 6 & 7
Greasing Compactor Mechanism ............................................. 7
Wiring Diagrams ...................................................................... 8
Parts Lists .................................................................... 9 thru 12
SAFETY PRECAUTIONS
ALWAYS UNPLUG COMPACTOR FROM WALL OUTLET
BEFORE SERVICING.
The service information is intended for use by a service techni-
cian who is familiar with proper and safe procedures to be fol-
lowed when repairing electrical appliances and who is equipped
with proper tools and testing devices. Repairs attempted or made
improperly can result in personal injury or property damage. Haz-
ards may develop from improper assembly or adjustments. While
making repairs, persons not having the proper background may
subject themselves to the risk of injury or electrical shock which
can be serious or even fatal.
IMPORTANT - NOTE TO THE CONSUMER
If you perform service on your own Broan products, you must
assume responsibility for personal injury or property damage
which may result.
MODEL AND SERIAL NO.
IDENTIFICATION
The specification label with model and serial numbers is located
on the inside of the cabinet. It is visible after opening the drawer.
TRANSPORTING COMPACTOR
When transporting compactor, the ram should be electrically or
manually extended down into the drawer, preferably against a
load of stacked newspapers or other suitable material. If this is
not done, damage to the trunnion nut may occur.
Never transport compactor on its back or front. Damage to the
gearbox may occur. If it cannot be transported upright, it is pref-
erable to place it on its side.
MANUAL RAISING AND LOWERING OF RAM
Unplug compactor cord from wall socket. Remove back panel.
The ram may be raised or lowered manually by using a 15/16"
socket to turn the drive screw nut. Clockwise will lower ram,
counterclockwise will raise it.
15/16”
SOCKET
BAG INSTALLATION
DO NOT use plastic bags other than those which have been de-
signed for use in this compactor. Unauthorized bags can be-
come caught in the mechanism.
With the drawer extended to the second stop, release the con-
tainer latch and swing open door. Slide bag into drawer from
front to back. Fold bag over top rim of drawer on all sides.
Press bag into all corners of the drawer. Smooth and shape the
bag carefully - this will prevent the bag from being torn by the
ram during compaction.
Using buttons on side of drawer, button bag in place by using
prepunched holes in side of bag. NOTE: If you have difficulty
installing bag, move drawer to second stop by lifting front of
drawer slightly and pulling forward (place on rug or other sur-
face to protect floor). This
will clear back of contain-
er from housing for easi-
er bag installation.
Swing door shut and latch
it. Bag is locked between
door flange and drawer.
When door is closed and
latched properly, door
guide “V” will be snug in
“V” groove in drawer
flange. Bag should be cap-
tured in “V” guide. Failure
to align “V” properly or to
latch drawer to door will
cause the compactor to
function improperly.
PREPUNCHED HOLES
DRAWER BUTTONS
“V” GROOVE
CONTAINER
LATCH