Filter
Top Products
MODELS 15XEWH • 15XEBL • 15XESS • 15XESSA
15XEWT • 15XETT
Page 9
M a i n t e n an c e
CLEAN RAM
1. Make sure the trash bucket is empty and pushed into
the cabinet.
2. Turn the Key Lock Switch to “ON” position.
Key Lock Switch
3. Select the “Hold” compact mode.
Hold Compact Mode
4. Close the door.
5. Press the “Start” button.
Start Button
The ram will travel downward into the trash bucket and
stop at the bottom of its stroke.
CAUTION: Glass fragments and other sharp trash
pieces may be on or around the surfaces to be
cleaned. Carefully remove these objects before
wiping down any surfaces.
6. Open the door. Unlatch and lower the bucket front.
Vacuum top of ram and clean with a mild detergent
solution.
7. When finished cleaning:
Raise and re-latch bucket front, close door, and press
“Start” button. The ram will return to the top of its
stroke and automatically shut itself off. Open door,
slide bucket out, install bag, and select compact
mode. Compactor is now ready to receive trash.
Compact Mode
On
Normal
Hold
Compact Mode
On
Normal
Hold
RAM
TRASH
BUCKET
AND CLEAN INTERIOR
11. CLEANING (continued)
1. Pull out trash bucket until it stops.
2. Remove (1) screw from each of the bucket slides.
3. Press down on left and right bucket slide release tabs
while pulling the bucket out of the unit.
4. Vacuum and clean cabinet base, track channels, and
bucket, particularly in corners.
5. Wash the cabinet interior with a mild detergent solution.
6. When finished cleaning the cabinet, install the trash
bucket by reversing steps 2 and 3.
CLEAN COMPACTION PLATE
1. The ram is equipped with a compaction plate that is
coated with Microban
®
anitmicrobial protection and
can be removed for easy cleaning.
2. Make sure the trash bucket is empty and without a bag.
3. Push the trash bucket into the cabinet. Unlatch and
lower the bucket front.
4. Press the compaction plate release tab on the front
of the ram to disengage the plate. The plate can be
removed by pulling down and away from the ram.
5. Once removed the compactor plate can be washed in
a mild detergent solution or placed in a dishwasher.
Cleaning will not affect the Microban
®
coating.
6. Re-install the compactor plate by inserting the tab
(on the rear of the plate) into the slot (at in the rear
of the ram). Press up on the front of the plate until it
securely latches in place.
Microban
®
is a registered trademark of the Microban Products Company.
RELEASE
TAB
COMPACTION
PLATE
RAM