Filter
Top Products
- 7 -
LIGHT
SWITCH
BLOWER
ON-OFF
SWITCH
BLOWER
SPEED
LOWER
BLOWER
SPEED
HIGHER
BLOWER
SPEED
HIGHEST
TIMED
SHUT-
OFF
RESET
OPERATION
Controls
The hood is operated using the (7) push-but-
tons located at eye-level, on the front of the deco-
rative flue.
The light switch turns the halogen lights on
and off.
The blower on-low / off switch turns the blower
on to its previous running speed. The blower
must be turned on using this switch. Turn the
blower off by pressing this switch a second time.
The blower speed lower switch lowers the
blower’s running speed. This switch works only
when the blower is already running.
The blower speed higher switch raises the
blower’s running speed. This switch works only
if the blower is already running.
The blower speed highest switch turns the
blower on to its highest running spped. This
switch works at any time.
The timed shut-off switch allows the blower to
run for 10 or 20 minutes before shutting itself
off. Push the switch once to set for 10 minutes -
twice to set for 20 minutes. This switch works
only if the blower is runinng.
The pilot light above the reset switch will light
after the blower has run for 30 hours. This is a
reminder to clean the grease filter. Once the
grease filter has been cleaned and replaced,
push the reset switch to turn out the pilot light
and start a new 30-hour count.
HALOGEN BULBS
This range hood requires two halogen bulbs
(Type MR16, 12V, 20W).
To change bulbs:
1. Remove the grease filter.
2. Remove bulbs by pulling them straight down-
ward. Do not rotate bulbs.
3. Replace bulbs by aligning the bulb’s pins with
the receptacle holes and pushing bulb up-
ward.