Filter
Top Products
Page 8
SPRAYHEAD
1. Open the pod door with the "OPEN/CLOSE" switch.
2. Disconnect brewer from power source and allow to cool.
3. Unscrew sprayhead counterclockwise (looking from below). Fig 8-1
4. Remove sprayhead and seal from holder.
5. Check and clean the sprayhead. The sprayhead holes must always remain open. Clean all the holes in the
plastic sprayhead to remove any mineral deposits. Wash and rinse in sink. Fig 8-2
6. When reassembling sprayhead, be sure to have seal installed with ridge facing up (A). Fig 8-3
FIG 8-2
SHOWN UPSIDEDOWN
FOR CLARITY
FIG 8-1
REMOVE - CCWREMOVE - CCW
INSTALL - CWINSTALL - CW
FIG 8-3
CLEANING
The use of a damp cloth rinsed in any mild, nonabra-
sive, liquid detergent is recommended for cleaning
all surfaces on Bunn-O-Matic equipment.
41167.1 051508
FIG 8-4
BIN /DRIPTRAY
1. Pull the driptray assembly straight towards you.
2. Pull the bin straight out and empty as required.
3. Seperate the parts as shown in Fig 8-4 and wash
with mild, nonabrasive, liquid detergent.
4. Assembly is in reverse order.
A