Filter
Top Products
Page 7
OPERATING CONTROLS
ON/OFF SWITCH
Pressing the "ON/OFF" switch (indicator glowing) supplies power to
the brew station warmer, enables the brew circuit, and energizes the
tank refill circuit. Pressing the switch again (indicator not glowing)
stops tank refilling and brewing and de-energizes the brew station
warmer. Stopping a brew cycle after it has been started will not stop
the flow of water into the decanter until the funnel is empty.
NOTE – Hot water will be available at the faucet in a limited amount
when the "ON/OFF" switch is in the "OFF" position because the tank
will not refill.
BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle when the "ON/OFF" indicator is glowing.
NOTE – The "ON/OFF" indicator must be glowing to initiate and complete a brew cycle.
ADDITIONAL WARMER SWITCHES
Pressing any additional warmer switch so that the indicator is glowing, supplies power to the associated
warmer.
READY INDICATOR
This indicator glows when the preset temperature has been achieved. The word "NOT" above "READY" will glow
in all other instances.
P1626
29707.1 021004
CLEANING
1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
2. Check and clean the sprayhead. The sprayhead holes must always remain open.