Filter
Top Products
11
REMOVING THE DECHAFFER
AND CUTTING BURR - If a small
piece of foreign material becomes
jammed in the lower cutting burr,
disassemble and clean as follows;
Step 1.Unplug the unit - Be sure
to remove the plug from the outlet.
Step 2. Locate and remove the
hex key - The hex key is located
below the power cord on the back
of the unit. Remove the hex key.
Step 3.Empty hopper - Remove
the coffee collector and hopper lid.
Empty the coffee beans from the
hopper.
Step 4. Locate hex screw - Turn
the coffee grinder upside down and
locate the hex head screw in the
center of the dechaffer. Be sure to
read WARNING label.
Locating Hex Key
Step 5. Remove hex screw - Using
hex key, remove the screw from the
center of the dechaffer. This screw
has left-hand threads and must
be turned clockwise.
Step 6. Remove parts and clean -
Remove the dechaffer and the burr.
Brush and clean as required.
Step 7. Reassemble - Make sure
the motor shaft aligns with the
rotating burr and that no foreign
material is in this area. The screw
has left-hand threads and must
be turned counterclockwise.
Store the hex key.
SERVICE - DO NOT disassemble
the unit. No user serviceable parts
are inside. Refer to Page 14 if
service is necessary.
Removing Cutting Burr
HEX
KEY
LOCATION
NOTE: TURN SCREW
CLOCKWISE TO REMOVE
HEX SCREW
CUTTING
BURR
DECHAFFER