Filter
Top Products
Page 12
ENABLE ENERGYSAVR
This function allows the operator to enable the ENERGY
SAVINGS mode function and set the idle time. Once
the set idle time has expired, the operator can choose
to have the heaters either turn off, or reduce the tank
holding temp to 140° F (60° C).
Procedure to enable energy savings mode:
Range: 0.5 to 24.0 hrs
If enabled, default setting is 140° F (60° C) tank tem-
perature after 4.0 hrs. idle time.
1. Press and hold the right hidden switch until the
display reads SET LANGUAGE. Press the right
hidden switch until the display reads Enabl Ener-
gySavr. The YES or NO will be flashing to indicate
the current selection.
2. Press and release NO to disable this function, or:
3. Press and release YES to enable this function (the
heaters will either turn off or the tank will hold at
140° F).
4. When finished, press and release DONE to save
the new setting and advance to the next function
screen.
5. If NO was selected, the display should now read
SET NEW RECIPE ?. To exit programming and
return to the MAIN SCREEN, press and release
the ON/OFF switch (either for DUAL Brewers).
6. If YES was selected, the display should now read
X.X HRS -> IDLE. This screen allows the opera-
tor to set the amount of time the brewer is not in
use before nap mode engages. Using (-) and (+),
adjust the idle time. When finished, press and
release DONE.
7. The display should now read AFTER IDLE TIME?
Once the set idle time has expired, the heaters can
either be shut off or held at a lower temperature
of 140° F.
8. To have the machine shut off after the set idle time,
press and release OFF and then DONE to save the
settings. The display should read MACHINE OFF
AFTER X.X HRS, and then SET NEW RECIPE ?.
9. To have the heaters hold at the lower 140° F tem-
perature, press and release 140° and then DONE
to save the settings. The display should read
MACHINE AT 140° AFTER X.X HRS, and then SET
NEW RECIPE ?.
AFTER IDLE TIME?
OFF DONE 140°
MACHINE OFF
AFTER X.X HRS
MACHINE AT 140°
AFTER X.X HRS
SET NEW RECIPE ?
NO DONE YES
WITH NO FLASHING
PRESS DONE TO
ADVANCE TO
ENABLEFRESHTIMER
X.X HRS -> IDLE
(-) DONE (+)
Enabl EnrgySavr
NO DONE YES
WITH YES FLASHING
PRESS DONE
10. Once the idle time has expired, the display will
read either ENERGY SAVER...NO TEMPERATURE
or ENERGY SAVER...REDUCED TEMPERATURE,
depending on the settings. This screen will alternate
with PRESS ANY SWITCH TO RE-HEAT.
PROGRAMMING THE BREWER (cont.)
41342 101911