Filter
Top Products
5
GENERAL INFORMATION
NOTE - THE BREWER IS NOT READY TO PLUG-IN
Improper installation will result in permanent damage and void the
limited warranty. Read & follow the instructions on the next page.
■ This brewer is designed to remain plugged-in at all times
(except during initial installation or when cleaning).
■ A vacation switch is provided on the lower left side to completely
shut-off all electrical components when your plans take you away
from home for three or more days. Safety features, designed into the
BUNN
®
coffee brewer, make the daily use of this switch unnecessary.
■ Whenever the brewer has been shut-off or unplugged, fill the tank
with water and allow the water in the tank to heat to the proper
temperature before using (about fifteen minutes or until the heating
sound stops).
■ Your BUNN coffee brewer has a specially designed tank to keep the
water at the proper temperature. This constant supply of hot water
assures the correct method of brewing coffee, in less than three
minutes.
■ The brewed coffee flows into the decanter where it is kept at
serving temperature on the porcelain decanter warmer. The warmer
is controlled by the lighted on/off switch on the front of the brewer.
NOTE- The warmer switch only controls the decanter warmer.
■ While coffee is being brewed, the newest water in the tank is heated
to the proper temperature and held until needed.
■ The decanter lid reduces coffee evaporation and temperature loss.
■ Hot water, approximately 50°F hotter than that available from your
hot water faucet, is always available for other uses.
■ The brewer is equipped with a polarized cordset. One blade of the
plug is slightly larger than the other. This is a safety feature and
allows the plug to fit into the outlet only one way. If you are unable
to insert the plug into the outlet, try turning it over. If the plug still
does not fit, contact an electrician to update your outlet. Do not
attempt to bypass the safety aspect of this polarized plug.
■ The sprayhead will periodically become loose. Using extreme
caution not to burn yourself, retighten the sprayhead with your
finger tips.
NOTE- A severe burn may result if the sprayhead becomes
loose and falls off while brewing.