Filter
Top Products
6
INITIAL SET-UP
CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except
when specified in the instructions.
1. Remove the upper panel from the rear of the dispenser.
2. Make sure the toggle switch below the circuit board is set to the desired voltage (120 volts or 208/240 volts)
and the red switch on the circuit board is in the "SET" position.
3. Connect the dispenser to the power source and turn-on the water supply.
4. Place the master switch in the "ON" position.
5. Water will automatically flow into the tank to the proper level and shut-off. This will take approximately 7
minutes.
6. The water will heat to the factory default setting of 200° F (93° C) for most dispensers, and 90° F (32° C) for
other dispensers.
7. Refer to PROGRAMMING to set the tank temperature, ready temperature, and dispense volumes.
DRAINING THE DISPENSER
CAUTION - The dispenser must be disconnected from the power source throughout these steps.
1. Disconnect the dispenser from the power source.
2. Shut-off and disconnect the incoming water supply
3. Remove the 4-40 screws at the sides of the top panel.
4. Gently remove one of the grommets from the tank lid.
5. Insert a syphon tube to the bottom of the tank and syphon ALL of the water out.
CLEANING
The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
WALL MOUNTED INSTALLATION
If the dispenser is wall mounted, the bottom of the dispenser should be at the same height as a counter or
table top. Use B.O.M. part #12542.0000 for side mounted Wall Bracket Kit or # 13125.0001 for front mounted
Wall Bracket Kit .
SUPPORT FOR LARGE RECEPTACLES
CAUTION: If the dispenser is to be used with larger receptacles such as pitchers or pots, those receptacles must
be adequately supported during dispensing of hot water to avoid spillage of very hot water. This support may be
provided by a table or counter top, or use B.O.M. part #12599.0000 Shelf Kit.
39338 012609