Filter
Top Products
22
POWER SWITCH
FIG. 22-1 POWER SWITCH (ICB SHOWN)
Location:
The power switch is located on the lower right
side of the trunk (ICB) or lower rear panel (ITCB).
Test Procedure:
1. Disconnect the brewer from the power source.
2. Disconnect the wires from the power switch. With
the switch in the ON position, check for continuity
between the upper and lower terminals on each
side of the switch.
There should be continuity between the two left ter-
minals and between the two right terminals when ON,
no continuity when OFF.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Disconnect the brewer from the power source.
2. Disconnect the wires from the power switch.
3. Remove the switch mounting screws from the left
side of trunk.
4. Install new switch in trunk with the two 6-32 x ¼˝
mounting screws.
L2
L1
FIG. 22-2 ROCKER SWITCH
42461 0911809
FIG. 22-3 TOGGLE SWITCH