Filter
Top Products
10
PROGRAMMING CUP SIZES - Portion Control Models
The cup size can be programmed in portion control models by “EXAMPLE” or “TIME”. Programming by EX-
AMPLE is manually pressing desired dispense button, then releasing when the desired cup size is attained. The
time required to fill the cup will be stored in the controller memory when moving to the next menu. Program-
ming by TIME is setting the actual dispense time in seconds for each cup size desired.
Place the “NORMAL/PROGRAM/RINSE” switch in the “PROGRAM” position. Press button A (page 8) below
the BUNN logo on front of the door until the “SET CUP SIZE” menu is reached. (Refer to menu J, page 12) Press
button D (page 8) to select programming by “EXAMPLE”. Place proper cup under dispense tip for station you
desire to set. Press desired dispense button, then release when the cup is 3/4 full. If cup is not full enough, the
dispense button can be pressed again to add additional beverage to the cup. If cup has reached desired level,
press button B under “SAVE” to record the dispense time. If cup is overfilled, press button D under “REPEAT”.
Empty cup and repeat the process.
If setting cup sizes by “TIME” is desired, press button B under “TIME” in the “SET CUP SIZE” menu. “HEAD
1 SM TIME” will be displayed, along with current time setting. Pressing either button D below (-) or button B
below (+) will subtract or add time in .1 second increments. Each one second of time equals approximately 1.25
ounces of beverage at factory settings. When desired time is set, press button A to continue to next cup size.
When the desired cup sizes have been programmed, press button C to exit program menus, or press button
A to move to the next menu. If button C was selected to exit the program mode, return the “NORMAL/PRO-
GRAM/RINSE” switch to the “NORMAL” position to return to nomal operation.
PROGRAMMING LOCKOUT SWITCH
This switch can be set to prevent access to the
programming mode of the dispenser. Once all the
correct settings are programmed, the operator can
set the switch to the “ON” position to prohibit anyone
from changing the settings.
P3060
NORMAL/PROGRAM/RINSE switch:
NORMAL: Allows all dispenser functions. Must be in this position for dis-
pensing.
PROGRAM: Allows access to program menus using touch pad and LCD
screen.
RINSE: Disables hopper motors. Pressing dispense button on front door
will dispense dilution water and power whipper motor for ten seconds.
PROGRAMMING THE DISPENSER (cont.)
P3060
38987 032306