Filter
Top Products
9
Digital Beverage Control
Digital Beverage Control
STOP
PROGRAM HOME SCREEN
The screen above will be shown when the dispenser is ready for use. While the tank is heating, the water
temperature will be displayed until the ready temperature is reached.
PROGRAMMING THE DISPENSER
The following function screens are in order of appearance. Each screen will have instructions on how to
access, and the procedures to program the various functions of the dispenser. To enable programming, place
the “NORMAL/PROGRAM/RINSE” switch in the “PROGRAM” position.
IMPORTANT PROGRAMMING NOTES - READ CAREFULLY
To exit the programming mode at any time, press and release the exit (center) pad located on the front
switch panel. The display will return to the PROGRAM HOME SCREEN.
If none of the five programming switches are pressed within 90 seconds during the setup of the dispenser,
the programming of the function screen that is being set will be exited and the display will return to the PRO-
GRAM HOME SCREEN.
DISPENSE READY
BUNN IMIX
ABCDE
P3057
A. Enter program mode and advance to next menu
B. Incriment display value positive
C. Exit program mode
D. Incriment display value negative
E. Return to previous menu
Using the menu-driven display (MAIN SCREEN) on the front of dispenser, the operator has the ability to alter
or modify various functions of the dispenser. This allows for precise dispensing of various flavors of powdered
products.
Programming of dispenser is achieved by entering a certain function, then, by use of programming switches,
the operator can customize the dispensing process to their specifications.
To access the programming mode, and to scroll through different function screens, the programming
switches shown are used. There are five of switches that will be used for setup of the dispenser.
PROGRAMMING SWITCHES
38987 032306