Filter
Top Products
6
O
F
F
O
N
O
F
F
PREPARING THE BREWER FOR USE
NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do NOT plug in until Step #3.
O
F
F
O
N
O
F
F
Raise the hinged flip-lid.
NOTE: The post protruding from the screen is con-
nected to a stopper that controls the flow of water
into the tank. When lid is closed (post depressed), the
stopper is raised and water will flow into the tank.
Plug in the brewer.
Step 2
Slide an empty brew funnel into the brewer. Pour one
carafe full of water into the screened area on top of the
brewer (there is no need to have the lid on the carafe at
this time). Place carafe in position on the brewer. Close
lid. Wait three minutes to allow the water to flow into
the tank. Repeat this process. When the tank is full,
some water will flow through the funnel and into the
carafe. Leave the carafe in place.
P2559
P2561
P214
P2560
Step 4
Press the bottom of the vacation switch, located on
the lower left side of the brewer, to the “ON” (lower)
position. The vacation switch controls power to the
tank heater. Initially you will have to wait approximately
fifteen minutes in order for the water to reach brew
temperature.
Empty any water that has collected in the carafe.
The next page leads you through the five easy steps to
‘BREWING DELICIOUS COFFEE’
O
F
F
O
N
O
F
F
Step 1
Step 3