Bunn BT10 Coffeemaker User Manual


 
7
BREWING DELICIOUS COFFEE
O
F
F
O
N
O
F
F
O
F
F
O
N
O
F
F
Insert a BUNN
®
coffee filter into the brew funnel.
Be sure to use BUNN
®
coffee filters for proper
brewing. Order more paper filters direct from
BUNN
®
at www.bunn.com
Measure coffee into the filter and gently shake the
filter to level the bed of grounds. To determine the
amount of coffee to be used, see Page 8.
Make sure that the sprayhead is tight. Slide the brew
funnel into the brewer.
Raise the hinged flip-lid and pour a carafe of water into
the top of the brewer. See Brewing Tips (page 8) for pre-
heating the carafe. Place the carafe on the brewer, THEN
close the lid. Your BUNN
®
brewer will begin brewing
coffee immediately. Flip-lid should also remain closed
when brewer is not in operation.
P2562
P2563
P2564
P2561
P215
When brewing has stopped, remove the brew funnel
and discard the filter and grounds. Do not touch hot
grounds.
NOTE: Opening the lid during brew cycle will interrupt the flow of water into the tank,
but will not interrupt the brewing process. The brewed coffee already in the funnel
will empty into the carafe. When lid is closed, the flow of water into the funnel will
resume until the brewing cycle is complete.
WARNING: Do not close the lid after pouring in water, without the decanter in place.
Closing the lid releases the hot water.
Step 1
Step 2
Step 3
Step 4
Step 5
HOT WATER (USE WITH CAUTION)
The same basic steps can be used to obtain hot water by omitting the filter
and coffee. The water from your BUNN
®
coffee brewer is approximately 200°
F. This is hotter than the hot water from your faucet and must be handled
with care.