Filter
Top Products
UNPACKING THE COOKER
Unpack the components from inside the grill and oven: Check that the following parts
are present.
Grill pan and grid Grill pan handle
Baking dish Pan supports (2)
Oven shelves (2) Enamelled discs (4)
Literature
Aluminium burner bodies (4)
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved
carefully.
STABILITY BRACKET
One of the holes in the rear of the cooker can be
used to engage a stability bracket. The bracket
must be fitted to the wall behind the cooker.
The diagram is a guide to the correct height at
which the bracket should be from the floor .
CONNECTING TO GAS SUPPLY
The cooker is designed to match the depth of standard 600mm worktops. An adaptor
backplate should, therefore, be fitted within the shaded area shown to allow the
cooker to be pushed fully to the wall. If a forward facing backplate is used, it must be
chased into the wall.
Connection to the cooker should be made with an approved appliance flexible
connection to BS 669. A length of 0.9 to 1.25m is recommended. The length of hose
chosen should be such that when the cooker is in situ, the hose does not touch the
floor.
The temperature rise of areas at the rear of the cooker that are likely to come in
contact with the flexible hose do not exceed 70
o
C.
23
INSTALLATION INSTRUCTIONS
155mm
Floor to bracket.
530
300
200
250
250
550
680