Filter
Top Products
9
USE OF YOUR OVEN
INITIAL OVEN SETUP
CLOCK
• When powered up and prior to pressing any buttons the clock will flash 12:00 and will increase each
minute.
• To set the oven clock press the CLOCK button on the control panel once.
• The clock will blink indicating it is ready to be set and the AM or PM icon will be displayed.
• Set the correct time by rotating the TEMP/TIME knob on the right side of the control panel clockwise to
increase the time and counter clockwise to decrease the time.
• Once the present time has been selected, press the START button to set the time.
• A 12 hour clock display is the default but may be changed.
• If a 24 hour military type clock display is desired, press and hold the CLOCK button for 6 seconds. “12 hr”
or “24 hr” will be displayed and can be toggled by pressing the TIME/TEMP knob. Press START to select
the desired display type.
• Note: AM or PM will only be displayed during the setting of the clock.
FAHRENHEIT OR CELSIUS TEMPERATURE DISPLAY
• Temperature is displayed in Fahrenheit as a default but may be changed to Celsius if desired.
• To change the temperature readout to degrees Celsius select the BROIL mode and set it to HIGH.
• Start the mode and press and hold the TIME/TEMP button for 6 seconds. “F” (Fahrenheit) will be
displayed as the current mode as a factory default. It can be toggled to “C” (Celsius) by pressing the
TEMP/TIME knob. Press START to select the desired mode.
CONTROL BEEPER
• An audio beeper is used to indicate presses of the control, indicate alarm expiration, end of cycles, etc.
• The beeper may be disabled if desired.
• To disable the beeper, press and hold the DELAY COOK button for 6 seconds. “On” or “Off” will be
displayed (On is the default). The state of the beeper can be toggled by pressing the TEMP/TIME knob.
• Press START to select.
OVEN LIGHTS
• Oven lights may be turned On and Off by pressing the LIGHT button on the control panel.
• In a double oven both the upper and lower oven lights will be turned On and Off when the LIGHT button is
pressed.