Capresso 478 Coffeemaker User Manual


 
Select the number of cups you would like to brew by pressing the CUPS button.
If using oily coffee beans, press the OILY button.
Push the BREW button (Fig. 2). The cup icon will illuminate and there will be
a slight pause before grinding to allow the doors of the bean container and
coffee chute to open.
The bean container door will open, then the grinder will start grinding and the
ground coffee will push into the GoldTone filter.
NOTE: Once grinding is finished, there will be a slight pause as the door of
the bean container closes. The grinder will grind again for a few seconds to
clear out any coffee beans remaining in the grinder. The ground coffee chute
will shut and the brewing process starts.
CAUTION: As long as the grinder is in operation, DO NOT open the bean
container lid, DO NOT open the filter basket and DO NOT insert your finger or
any other object into the grinder.
After brewing is finished the cup icon light will turn off. For the next 1 to 2
minutes hot coffee will still pass from the filter into the carafe.
To serve coffee, remove the carafe from the platform.
Push and hold the pouring lever and slowly pour coffee.
IMPORTANT: If you hear a loud buzzing noise during grinder operation or if the
grinder gets blocked or jammed, push the brew button to stop grinding and
unplug the machine and follow cleaning instructions in chapters 10.5 to 10.7.
8.1 DRIP STOP / STOP AND SERVE
While the coffee is brewing you can remove the carafe to pour a cup or two.
The drip stop will close automatically.
To avoid any overflow, replace the carafe within 20 seconds.
CAUTION: The drip stop might not close completely allowing coffee to drip
onto the platform. In this case immediately place carafe back into the machine
and let all the coffee flow into the carafe.
After brewing is finished, check the GoldTone filter for any clogging and rinse
the filter insert to remove any coffee particles from the drip stop (Fig. 5).
8.2 GRINDING AND BREWING LATER ("AUTO")
Coffee maker is plugged in and the time and auto-on time are set.
Beans are in the bean container and bean container lid is on and pushed
down securely.
Fill the water tank with the desired amount of water.
Make sure the filter insert and GoldTone filter are in place and the GoldTone
filter is empty.
Make sure the filter holder is closed.
Insert the carafe with lid, into the machine.
Push the AUTO button briefly. The clock icon will illuminate on the display.
At the preprogrammed time, the clock icon will disappear, the cup icon will
illuminate and the grinding and brewing will start.
Recommendation: If you want your coffee ready by 7:30, set the auto-on
time to 7:15.
NOTE: See chapter 7.1, b for Setting the Auto-On Time.
13