Filter
Top Products
10.3 Filter Insert / Drip Stop: Clean the filter insert and the drip stop under
running water or in the dishwasher (upper rack, away from any heating element).
Test that the drip stop closes completely under running water (Fig. 5).
Periodically check that water can flow through the drip stop by filling the filter
insert with water and pressing down on the drip stop to check no particles are
stuck in the drip stop.
10.4 Bean Container: When the bean container is empty, use a dry cloth to
wipe off any oil deposits. Never pour any liquid into the bean container and
never wash under running water. Never try to disassemble the bean container.
NOTE: Always empty the filter prior to cleaning the bean container or ground
coffee chute so no moisture enters the grinder.
10.5 Grind & Clean Cycle:
The Grind & Clean Cycle can be used at anytime the machine is in standby mode
(Heating plate is off, brew light is not illuminated). This cycle will cut off the flow
of the beans and engage only the grinder. Any minor clogging caused by
grounds will be expelled into the filter basket. To run a Grind & Clean Cycle
simultaneously push and hold the "Ground Coffee" button and the "Auto" button
as shown below. It is recommend to empty all used grounds from the filter basket
before running a Grind & Clean Cycle.
10.6 Ground Coffee Chute: Periodically check the ground coffee chute
(Fig. 10 & 11) for oil and coffee build-up. The ground coffee chute should be
cleaned 1-2 times a week if you use the machine daily or if any of the following
situations occur:
• Heavy oil build-up has caused coffee to block the ground coffee chute from
opening.
• The ground coffee chute door is not closing all the way.
• You do not plan on using the grinder for more than a week.
Note: If extremely oily beans are used (i.e. French Roast) more regular cleaning
of the ground coffee chute may be required.
For cleaning, please follow this sequence:
• Remove the carafe and push the filter holder button (Fig. 6). Remove the
GoldTone filter and the filter insert and set aside.
• With the filter holder open, look inside the cavity of the machine and under
the grinder.
15
Simultaneously push and hold buttons for Grind & Clean Cycle