Filter
Top Products
15. CLEARYL BLUE WATER FILTER CARTRIDGE
The machine comes with one Clearyl Blue Water Filter Cartridge.
The Clearyl Blue cartridge
• Reduces the water hardness up to 75%.
• Removes (if present) up to 85% chlorine, up to 90% lead, up
to 95% copper and up to 67% aluminum.
• Cleans the water through an upward current principle (Fig. 8)
just before the brewing cycle starts, ensuring freshly filtered
water every time you make coffee.
• Lasts for 60 liters (~2,000 oz.) of water or up to two months.
• Eliminates decalcifying except when using very hard water
(30 grains or higher), see chapter 14a. In this case we
recommend to decalcify the machine once or twice a year.
• To reorder cartridges, see chapter 20.
15a. INSTALLING & ACTIVATING THE FILTER CARTRIDGE
Important: In order for the Clearyl system to work properly you
must install and activate the system (see below).
Installing:
Important: Never install the cartridge before or during
"Preparing Machine For The First Time" (chapter 6).
• Remove cartridge from its bag and rinse cartridge under water.
• Remove the water tank, make sure it is empty.
• Pull up the cartridge holder (Fig. 9) and insert the cartridge
with its tapered end down into the water container (Fig. 10).
Make sure it fits inside the fins and push down gently.
• Close the cartridge holder making sure it snaps into place (Fig. 11).
• Fill the water tank with fresh cold water and replace.
Activating:
You must activate the cartridge for the machine to monitor it
properly. Otherwise the C5 assumes decalcifying mode.
Your machine is turned off, but in stand-by mode. Only the ON
symbol is visible.
• Open the Access Door (Fig 1,2a).
• Push and hold the CLEARYL button until its light is on (Fig. 3a).
• Turn the DIAL until all three DIAL lights are illuminated.
• With the three lights illuminated push the DIAL to confirm the
activation process. The three lights begin to blink.
• Place a 20 oz. container under the steam nozzle (Fig. 15).
• Turn the SELECTOR to the Water symbol.
The C5 pumps water through the cartridge and out through the
steam nozzle for approximately 60 seconds. Initially, the water
may be discolored. The program will stop automatically.
• Turn the SELECTOR back to the Cup symbol.
The machine will return to stand-by mode. From now on, the
machine will monitor the flow of water. After using approx. 60
liters(~2,000 oz.) of water, the machine will remind you to
replace the filter (see below).
Please note: You can stop the water flow at any time by turning
the SELECTOR to the Cup symbol. Empty the container, replace
and turn the SELECTOR to the Water symbol to complete the
activation process.
Please note: As long as the filter is activated, the water hardness
setting is automatically turned off.
18.