Filter
Top Products
Automatic Pause ‘N Serve Drip Stop Valve
For your convenience, our Pause ‘N Serve feature allows you up to 30 SECONDS
to sneak a cup while the coffee is still brewing. It also prevents any remaining
coffee in the filter basket from dripping onto the warmer plate once the brew cycle
is completed.
TO PREVENT INJURY FROM HOT OVERFLOW, REPLACE DECANTER
WITHIN 30 SECONDS IF REMOVED DURING BREWING.
Cleaning Ins
tru
ctions
Your coffeemaker be cleaned when you begin to notice excessive steaming or the
brewing time increases considerably. This condition is caused by a buildup of lime and
mineral deposits from your water. If the pumping action stops before all the water has
been pumped out of the machine, then the
appliance
requires cleaning.
The frequency of cleaning depends on the hardness of water used. The following table
gives the suggested cleaning intervals.
1.
2.
3.
4.
5.
6.
7.
6.
Pour one quart of undiluted white household vinegar into your
coff
eemaker.
Place a
#4
cone filter into the filter basket and close the filter basket.
Place the empty decanter on the warming plate and
turn
the
coff
eemaker ON.
When three cups have flowed through, turn the coffeemaker OFF and let stand
for
l/2
hour.
After
l/2
hour, pour the vinegar back into the coffeemaker.
Place the empty decanter on the warming plate.
Turn
the coffeemaker ON
and let
all
of the vinegar flow through.
Discard the vinegar and the paper filter.
To flush out all traces
of vinegar, pour
a
decanter full of tap water into the
coff
eemaker, turn it ON, and allow it all to
cycle
through.
Discard the water and
turn
the coffeemaker OFF. Repeat steps 7 and 6.
Decanter Cleaning
Hard water
.can
leave a whitish mineral deposit inside the decanter. Coffee and tea
discolor these deposits, sometimes leaving
a
brownish stain inside the decanter.
To remove these stains, follow these simple steps:
1.
Use
a
solution of equal parts white vinegar and hot water.
2.
Let solution stand in decanter for about 20 minutes and then discard.
3.
Wash and rinse the decanter thoroughly using a soft cloth. Do not use harsh
abrasive cleaners. These may cause scratches which can lead to breakage.