Capresso MG600 Coffeemaker User Manual


 
10
MG600 (Glass carafe):
When all the water is passed through,
the coffee maker will keep the coffee
hot for two hours. Then it will shut off.
If you need to keep the coffee hot
longer, just push the On/Off button
again.
5g. Pouring Coffee While Brewing
You can pull the carafe from the plat-
form during the brewing process for
approx. 20 seconds to pour a cup in
between.
MT600 (Stainless steel carafe):
Make sure to close the lid before you
replace the carafe.
5h. Brewing Small Amounts of Coffee
When brewing small amounts of coffee
(3 to 5 cups) push the 3-5 cup button
first. The green indicator light will go
on. Then push the On/Off button. The
red indicator light will go on. The
brewing process will be slowed down
to allow the coffee to reach its full
aroma.
If you pushed the 3-5 cup button by
mistake, just push it again to turn off
this function.
Stainless steel carafe: When brewing
3-5 cups of coffee the temperature in
the carafe will be approx. 3 to 5
degrees lower than on a full pot.
5i. Making Multiple Carafes of Coffee
If you want to make another carafe of
coffee immediately after the first pot,
make sure the machine is off and
allow to cool down for three minutes
before refilling the water tank.
Important: Make sure the carafe is
empty before brewing.
6. Automatic Brewing at a
Pre-Programmed Time
Set the programmed time at which
you wish to brew coffee as described
in chapter 2d.
Make sure that the programmed
time is correct (AM or PM).
Hint: If you want your coffee ready by
7:15 AM, set the programmed time to
7:05, i.e. 10 minutes earlier. This way
you get the freshest and hottest
coffee possible.
Important: Avoid any air conditioner
blowing cold air against the thermal
carafe. This will cool down the carafe
overnight and reduce the coffee
temperature in the carafe.
Fill the water tank and filter holder
and place the empty carafe with the
closed lid on the platform (chapter 4).
Push the "auto" button (Fig. 2, L).
The green indicator light above this
button will go on.
At the pre-programmed time, the red
on button will go on and the green
auto light will go off, indicating that
brewing has started.
Important: If you pushed the auto
button by mistake just push it again
to turn it off.
7. Handling of the Stainless Steel
Thermal Carafe
The lid of the thermal carafe has a
pouring indentation to make it possible
to pour with the lid in place (black
dot pointing at the spout, Fig. 12).
Always make sure that the carafe is
transported in an upright position.
If you turn the carafe with its lid
closed on its side or turn it upside
down, hot coffee will flow into the
grooves of the lid and exit through
the side of the lid (Fig. 13).
Important: A stainless steel bottom
covers the vacuum seal of the stain-
less steel body. Do not try to remove
this cover. Do not place the carafe on
any hot surfaces since this can loosen
the vacuum seal inside the bottom.
This can cause the carafe to lose its
thermal function.
Do not place carafe in dishwasher.
8. Cleaning the Coffee Maker
Make sure coffee maker is turned
off (Red light is off). Always unplug