7.9 Filling The Water Container
Open the water container lid (I)
and pour the desired amount of
fresh, cold water through the filtra-
tion container (K).
Note: Using the
cup graduation on the glass carafe,
always pour approximately one
cup of water more into the water
container to compensate for water
lost during the brewing process.
Maximum amount of cold water:
approximately 1/4 inch above the
10-cup marking on the glass
carafe.
When you have filled the water
container,
set the glass carafe
aside (do not set it on the heat-
ing plate (H) yet!).
7.10 Filter Holder Insert
Caution
: If the filter holder insert
(M) is not completely locked into
the filter holder (O), the drip stop
(N) on the bottom of the filter holder
insert might not open during brew-
ing. This can cause hot coffee to
overflow and can result in serious
injuries and damages. Here is how
to properly lock the filter holder
insert into the filter holder:
• Open the water container lid.
• Remove the cover lid.
• Remove the glass carafe from
the heating plate and then lower
the filter holder insert (M) with
the tab of the filter holder insert
pointing towards the water con-
tainer. Push the handle of the
filter holder insert down towards
the water container and make
sure it sits completely flush with
the rim of the filter holder (O).
• Push with your finger against
the drip stop (N). If the filter
holder insert is in the proper
position, it will stay inside the
filter holder and not move
upwards.
12
Hot Water Guard
see page 21, question 10
Filter
holder
insert
Filter
holder
CAUTION: Messy / Dangerous!
If you forget to place the filter holder insert (M) in the filter holder
(O) and you slide the filter holder underneath the grinder, it will
start grinding and spread the ground coffee on your counter. It
will then return the filter holder underneath the water container lid
and the
brewing process will start, splashing hot water onto
the heating plate. In this case, immediately push the On/Off
button to turn off the machine and wait until the water pump-
ing stops!
Always move the filter holder WITH the filter holder insert AND the
GoldTone filter underneath the grinder.