Filter
Top Products
• If the machine is unplugged or if you have a power interruption
for more than 2 to 3 minutes, the time function will be lost. If
the coffeemaker was set to AUTO no coffee will be ground and
the filter will still sit underneath the grinder. If the machine was
brewing coffee before the power interruption, it will not continue
brewing.
If power comes on again the display will show
TIME<AM>. Yo u
must set the time again (Chapter 7.2a). Please note: Your personal
grinding settings and the Auto-on time are still maintained.
7.4 Filling the Beans
Fill the bean container (Fig. 1,B) with beans. Make sure that the
water container lid is closed to prevent beans from spilling into
the water container.
Caution: Check beans for foreign objects (see page 4, chapter 2e).
The bean container will hold approximately 90 grams of beans
(good for almost two full pots of coffee). Select the fineness
setting (Fig. 3) by turning the bean container until the line matches
up with one of the four dots in front of the bean container. For
first time use, we recommend the coarsest setting – the largest dot.
Note: Never fill the bean container with frozen or coated beans
(see chapters 2a and 2d, page 4).
7.5 Filling The Water Container
Open the water container lid (Fig. 1,E) and fill the water container
with the desired amount of fresh, cold water.
Please note: Never fill water above the "MAX" line on the water
container.
7.6 Filter Holder Insert
Caution
: If the filter holder insert (Fig. 4) is not completely
locked into the filter holder, the drip stop on the bottom of the
filter holder insert might not open during brewing. This can cause
hot coffee to overflow and can result in serious injuries and
damages. Here is how to properly lock the filter holder insert into
the filter holder:
• Open the water container lid (Fig. 1,E).
• Remove the cover lid (Fig. 5).
• Remove the carafe from the pedestal and then lower
the filter holder insert with the tab of the filter holder insert
pointing towards the water container. Push the handle of the
filter holder insert down towards the water container and
make sure it sits completely flush with the rim of the filter
holder (Fig. 4).
• Push with your finger against the drip stop (Fig.6). If the filter
holder insert is in the proper position, it will stay inside the
filter holder and not move upwards.
• Insert the GoldTone Filter (Fig. 1,G).
• Place the Cover lid on top of the filter holder insert. Make sure
it sits flush inside the rim of the filter holder (Fig. 5).
CAUTION: Messy / Dangerous!
If you forget to place the filter holder insert in the filter holder
and you slide the filter holder underneath the grinder, it will start
grinding and spread the ground coffee on your counter. It will
then return the filter holder underneath the water container lid
and the
brewing process will start, splashing hot water
everywhere. In this case, immediately push the On/Off button
to turn off the machine and wait until the water pumping
stops!
Always move the filter holder WITH the filter holder insert AND the
GoldTone filter underneath the grinder.
10.