Filter
Top Products
13.
"NOW" grind setting, to the Auto-On time and the Auto grind
setting. At the programmed time, the green light will turn off,
the red light in the On/Off button will illuminate, and
the grinding / brewing process will start.
10. Cleaning
CAUTION:
Make sure machine is turned off and cooled down.
Never use scouring agents. Never immerse the machine in any
liquid. Never clean machine under running water.
Dishwasher safe (upper rack):
GoldTone Filter and Filter holder insert.
Special Cleaning Tips:
10a. Cover Lid:
Wipe the cover lid clean after each use.
Do not clean in the dishwasher. If the soft collar becomes
separated from the hard disk, simply replace it with the high rim
pointing upwards (Fig. 5).
10b. GoldTone Filter: Clean after brewing. Do not let used
coffee sit for hours in the filter. Coffee oils will clog the mesh,
causing the coffee to overflow the next time you brew coffee.
10c. Filter Holder Insert /Drip Stop: Clean the filter holder
insert and the drip stop under running water. Check that the drip
stop closes completely under running water also.
10d. Bean Container: When the bean container is empty, use a
dry cloth to wipe off any oil deposits. Never pour any liquid into
the bean container. Never try to disassemble the bean container.
10e. Burr Grinder/Burrs:
It is possible that small coffee particles might stick to the burrs.
Once every 2 months let the bean container run out of beans.
Remove the carafe. Make sure the GoldTone filter is inserted.
Move the filter holder underneath the grinder. Set the fineness
selector to the largest dot. Push the on/off button. While the
machine is grinding tilt the whole machine a bit forward and pat
it on the back. This will loosen any coffee particles and transport
them into the filter holder. Repeat if necessary.
10f. Cleaning The Feeder Channel
Periodically check the feeder channel for oil and coffee build-up.
As long as you can see coffee flowing freely through the feeder
channel window there is no need to open the cover.
The feeder channel should be cleaned in any of the following
situations:
• moisture or heavy oil build-up has caused the ground coffee
to block the feeder channel, or
• you do not plan on using the grinder for more than a week.
For cleaning, please follow this sequence:
• Make sure the GoldTone filter or a paper filter is inserted in the
filter holder insert.
• Move the filter holder underneath the grinder until it locks.
• Lift the Feeder Channel Cover and set aside (Fig. 12).
• Use the handle of the scoop to scrape out blocked coffee
into the filter holder (Fig. 13).
• Wipe the inside clean with a dry cloth.
• Push the manual release button (Fig. 14). The filter holder will
swing back to the right.
• Wipe the inside of the feeder channel cover with a dry cloth
(do not immerse in water).
• Replace the feeder channel cover.
• Empty the GoldTone filter or paper filter.