Filter
Top Products
1. Equipment
The ST600 comes with: Stainless
Steel Vacuum Thermal Carafe with
Lid, Goldtone Filter (inserted into the
removable Filter Holder), Measuring
Scoop, Charcoal Filter with Charcoal
Filter Holder, this operating instruction
booklet and a Mail Order Form.
2. Preparing the ST600
2a. Before First Use
After unpacking clean all loose parts
with warm water and make yourself
familiar with the different functions.
After reading these instructions, let
some water run through the coffee
maker to clean all internal parts.
• Push the Release button beneath
the Capresso logo. (Fig.1,E).
The Pop-up lid will flip open (Fig.1,A).
On the left is the water tank with out-
side water level indicator. The remov-
able filter holder with drip stop and
removable Goldtone Filter are located
in the middle. To the right you will find
the operating buttons and the display.
2b. The Display
The Pop-up lid is open.
• Pull the power cord (Fig.10) to the
required length (max. about 38”).
You can always push unneeded
cord back into the machine.
• Plug in the machine.
The display will illuminate and will
flash AM 00:00 for five seconds.
The flashing will stop and the
illumination dims.
2c. Setting the Current Time (Fig. 2).
• Push the H button down for a
second and release. Now the display
flashes.
•
Push the H button r
epeatedly until
the actual hour is set. W
atch how
the AM / PM indicator changes.
• Now push the M button to set the
minutes. The display will flash five
times after your last setting and will
dim and show the actual time.
• To change the time, just push the
M or the H button for a second and
release. The display flashes and you
can repeat the above procedure.
Please note: When you disconnect
the machine from the power source or
if your power circuit is interrupted
(power outage) the machine will lose
all settings. You must set the time and
the Auto-on time again.
Please note: You must change the
clock (not the Auto-on time) when the
time changes (Standard Time,
Daylight Savings Time).
2d. Setting the Auto-on Time.
• Push and hold the H button down
until the display flashes 11:11.
• Release the button and now push
the H button again until the desired
Auto-on hours are displayed, then
push the M button for setting the
minutes. When finished, the
display will flash five times and
then revert to the actual time.
• To check the Auto-on time, push
the H button down until the display
starts flashing (at this time it shows
the Auto-on time). Release the H
button and the display reverts to
the actual time.
• To change the Auto-on time, push
and hold down the H button until
the display starts flashing.
• Release the button and set the new
Auto-on time.
3. The Charcoal Filter
Most tap water is treated with chlorine.
The charcoal filter removes up to 82%
of the chlorine and other impurities
found in tap water, improving the
taste of water. If you use spring or
bottled water it is not necessary to
use the charcoal filter. However water
might attract impurities when sitting in
the water container overnight. The
char
coal filter will remove most of
these impurities since the water will
be filtered just before entering the
heating element.
7